Hey Gang--Check it out!! If you have a Gasser or a Front Engine Dragster I have what you need--I am an engine builder by trade--I have a nice FED I have been running for a while--well...I have a couple spare engines I am selling--reason is I am going to NITRO--these were built for methanol and compression is too high to run the amount of Nitro I am planning--read on.... 030 over 350 010 high nickel block--fully race prepped--Eagle lite weight forged crank--lentz style I beam rods with 7/16ths ARP--Milodon dragster style oil pan ( can swap to car pan easy as pie--I will do it for free) King HP bearings, Ross super lite domes with gapless rings--Isky solid roller 255/260 605 lift on a 106 LSA--Trick Flow heads ported--quality valves--Comp Pacoloy springs ( $480) titanium retainers. Enderle front cover with fuel pump spud ( extension in pix NOT included) USA made Scorpion rockers with Jomar girdles This engine is 13.7:1 Compression ratio It has run about 50 laps then I freshed it up just for grins--It has run a 5.38 in my FED It rev's like a chainsaw and makes PLENTY of power!! NO way it can be built for what I am asking I just need lower CR so I can burn me some 50% Yahoo I am offering a fresh ready to rock high quality engine--I will crate for free and ship anywhere cheap as dirt or you can pick up in North Carolina Calls ONLY no text or private message contact me [email protected] or best to CALL 704 244 6649 You will be very happy with this little SBC!!