Register now to get rid of these ads!

Technical Cut, Bend & Weld

Discussion in 'The Hokey Ass Message Board' started by jimvette59, Jul 7, 2020.

  1. jimvette59
    Joined: Apr 28, 2008
    Posts: 791

    jimvette59
    Member

    Hi I just finished changing my 39 peddles for my channeled 27 Roadster on a model A chassis to work on a Tardal 32 cross member.

    DSCN1261.JPG DSCN1272.JPG DSCN1273.JPG DSCN1274.JPG DSCN1275.JPG DSCN1276.JPG DSCN1277.JPG DSCN1278.JPG DSCN1279.JPG DSCN1280.JPG
     
    Last edited by a moderator: Jul 7, 2020
    loudbang, GordonC and anthony myrick like this.
  2. Paul
    Joined: Aug 29, 2002
    Posts: 14,808

    Paul
    Editor

    Very nice,
    please post pictures of them installed
    When you can
     
    loudbang likes this.
  3. jimvette59
    Joined: Apr 28, 2008
    Posts: 791

    jimvette59
    Member

    We are still in mock up stage. They work for me. DSCN1281.JPG DSCN1284.JPG DSCN1285.JPG DSCN1287.JPG DSCN1288.JPG
     
    loudbang likes this.
  4. Wanderlust
    Joined: Oct 27, 2019
    Posts: 128

    Wanderlust

    Pedals are nice but I hope the chip board is just for templates, will not last long, swell up and fall apart.
     
    loudbang likes this.
    Register now to get rid of these ads!

  5. That's OSB (oriented strand board), not particle board. You can use that stuff anywhere plywood will work...
     
    loudbang likes this.
  6. jimvette59
    Joined: Apr 28, 2008
    Posts: 791

    jimvette59
    Member

    Ha Ha Ha we are very much still in mock up stage and OSB was laying around.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.