Register now to get rid of these ads!

Cost to sleeve a block / NJ Machine shop?

Discussion in 'The Hokey Ass Message Board' started by rld14, Jul 3, 2011.

  1. rld14
    Joined: Mar 30, 2011
    Posts: 1,609

    rld14
    Member

    As the work continues on the Vauxhall I have realized that I am WAY past Kroil.

    Quick and dirty.. engine got a lot of water in it while it was sitting, soaked cylinders in Evapo-Rust, they cleaned up nice, 3 have small pits, Cylinders #3-6 are still stuck frozen after nearly 4 weeks of soaking in Kroil.

    Sooo... Cylinders are unobtainium, so looks like the way to go is new rings and sleeve the block. It's a 2262cc inline 6, crank and bearings are perfect, cam is fine, but I figure that sleeving the block and new rings should fix me up nicely.

    Anyone suggest a good machine shop in North Jersey? And, ballpark, what should I expect to pay for such a job?

    Thanks in advance!

    Bill
     
  2. call Joe & Mike Bontempo 1539 W. Blancke Street Linden,N.J. 908-862-6336
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.