Register now to get rid of these ads!

Hot Rods Chevy slave cylinder mount

Discussion in 'The Hokey Ass Message Board' started by hotrodder1932, Aug 9, 2018.

  1. hotrodder1932
    Joined: May 3, 2010
    Posts: 35

    hotrodder1932
    ALLIANCE MEMBER

    Does anyone make a chevy slave cylinder mounting bracket that works with a small block and the 1962 truck slave cylinder? I am using the early dual master cylinder and rotten Leonards pedals. Thanks. Tom
     
  2. Dennis D
    Joined: May 2, 2009
    Posts: 525

    Dennis D
    Member

    like this? I made this one myself out of some scrap angle. You may check on some of the off road truck sites. D
     

    Attached Files:

  3. This is mine. Piece of 1/4" stainless I had laying around. Small hole is for a 1/8" roll pin in case it wanted to pivot.
    221-013.JPG
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.