Register now to get rid of these ads!

Cass Nawrocki book sold out

Discussion in 'The Hokey Ass Message Board' started by rouye56wingnut, Feb 1, 2013.

  1. rouye56wingnut
    Joined: Jan 14, 2008
    Posts: 352

    rouye56wingnut
    Member
    from mn.

    Cass is out of books unless he does a reorder . However if you still are looking for one get ahold of Ron Fournier or Stan Fulton as they have the last few available .
     
  2. NickJT
    Joined: Jul 17, 2012
    Posts: 640

    NickJT
    Member
    from S.E. PA

    I wish you would have let me know last week before they were sold out. I'll try to get in touch with Ron or Stan.
     
  3. rouye56wingnut
    Joined: Jan 14, 2008
    Posts: 352

    rouye56wingnut
    Member
    from mn.

    How would I be able to tell you last week when I just found out yesterday from Cass?
     
  4. NickJT
    Joined: Jul 17, 2012
    Posts: 640

    NickJT
    Member
    from S.E. PA

    Don't you have a flux capacitor?!!??
     

  5. NickJT
    Joined: Jul 17, 2012
    Posts: 640

    NickJT
    Member
    from S.E. PA

    PS: no disrespect intended for this book about the highest levels of metal working art
     
  6. rouye56wingnut
    Joined: Jan 14, 2008
    Posts: 352

    rouye56wingnut
    Member
    from mn.

  7. pimpin paint
    Joined: May 31, 2005
    Posts: 4,937

    pimpin paint
    Member
    from so cal

    Hey,

    Is this book a '' must have '' for metalshapers? I know Cass has done some great work like the 540 Mercedes he hand built, but did his majic make it to print?

    Merci
     
  8. rouye56wingnut
    Joined: Jan 14, 2008
    Posts: 352

    rouye56wingnut
    Member
    from mn.

    This book in my opinion is a must for anyone that is trying to advance their skill sets to another level . There are alot of trinkets in the book that will make your head spin if you dont look closely to what he is showing .Check out what Street Rodders Mr. Hammer (Ron Covel) wrote about it . He was completely blown away about its content .
     
  9. BCR
    Joined: Dec 11, 2005
    Posts: 1,262

    BCR
    Member

    Yes!


    it is not a rehash of all the other metal shaping books. His book shows unique solutions that will teach even the most advanced metal man some new tricks in my opinion.
     
  10. this is a MUST have book.....
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.