Register now to get rid of these ads!

Technical Bead roller dies for any and all rollers

Discussion in 'The Hokey Ass Message Board' started by FiddyFour, Mar 10, 2018.

  1. FiddyFour
    Joined: Dec 31, 2004
    Posts: 9,008

    FiddyFour
    Member

    i've been getting a lot of renewed interest and PM's about bead dies as of late

    First question i get is "are you still making these?" at first, i thought no, i let them die due to lack of interest.. however...

    yes, i still make the classic tipping dies. i also make step dies, form sets, small bead dies and wide floor bead sets and custom sets. my prices have not gone up compared to hoosier or other custom profile makers and yes, i make them for damned near any roller platform, i just need your specs.

    PM if you need a set of dies. if i cannot make them for less than the other makers, i wont take your money!

     
  2. FiddyFour
    Joined: Dec 31, 2004
    Posts: 9,008

    FiddyFour
    Member

    Wide floor bead sets.


    28279129_166251117514221_5283847418290365256_n.jpg
     
  3. FiddyFour
    Joined: Dec 31, 2004
    Posts: 9,008

    FiddyFour
    Member

    Tipping set with steel upper and lower dies and optional delrin lower 20180118_134045.jpg
     
  4. FiddyFour
    Joined: Dec 31, 2004
    Posts: 9,008

    FiddyFour
    Member

    Also, please remember, the prices you see do not include the Traditional HAMBer 10% discount! no HAMB Alliance membership needed for this discount
     
    bct likes this.

  5. FiddyFour
    Joined: Dec 31, 2004
    Posts: 9,008

    FiddyFour
    Member

    Just a heads up, my lathe is down for the count for a bit. i should have it up and running again within a week. my lathe is 145 years old this year, so parts are made to order lol

    thank you for understanding
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.