Register now to get rid of these ads!

Projects Accel dual point dist. made to fit Flathead

Discussion in 'The Hokey Ass Message Board' started by RDAH, Mar 23, 2013.

  1. RDAH
    Joined: Mar 23, 2007
    Posts: 465

    RDAH
    Member
    from NL, WI

    Me & a machinest friend made 4 to sell at swap meets for $100 each. They fit 49 - 53 Flatheads use single Ford points. Or you can run a Ford Pretronix in them. They are Accel GM dist. with the small cap for female plug wires. They are set up for 24* of advance at 2,200 to 2,300 RPM. If anyone is intrested call me at. 920-982-2248
     
  2. gimpyshotrods
    Joined: May 20, 2009
    Posts: 17,904

    gimpyshotrods
    ALLIANCE MEMBER

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.