Register now to get rid of these ads!

51 chevy Door Glass Installation

Discussion in 'The Hokey Ass Message Board' started by blown240, Mar 19, 2006.

  1. blown240
    Joined: Aug 2, 2005
    Posts: 1,671

    from So-cal

    Does the door glass go in before the division bar and vent window, or does it go in last? and do you put the bottom channel on the glass while it is out, or once its in?

  2. 50chevy
    Joined: Oct 8, 2004
    Posts: 747


  3. Put the bottom channel on the glass first, then put the window in the door and hook up the window to the track system , then install the division bar and wing glass last.
  4. shortcut76009
    Joined: Jan 11, 2013
    Posts: 14


    Have you figured out the install? I'm having the same issue
    Register now to get rid of these ads!

  5. Dano382
    Joined: Dec 1, 2011
    Posts: 16

    from HB, CA

    I just did my driver door glass on my coupe. I dropped the glass into the bottom chanel first. Make sure to use adhesive or the glass might come out of lower channel after you put it all back together, happend to me:D.

    Then put in your division bar/wing window in and adjust the lower channel adjustment screw to make sure it cycles up and down smooth without binding up.

    I don't think you can get glass out or in with the division bar still in place.:rolleyes:

    Also left the glass holder on it's track because I installed new scrapers and it would pass thru with it attached to glass. Helps if you have another person to assist you.
    Last edited: Jan 11, 2013

Share This Page

Register now to get rid of these ads!


Copyright © 1995-2013 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.