Register now to get rid of these ads!

'49-'58 Chevy Truck Stock Track Width???

Discussion in 'The Hokey Ass Message Board' started by HotRodChassis, Jun 22, 2009.

  1. HotRodChassis
    Joined: Jan 23, 2005
    Posts: 2,283

    HotRodChassis
    Alliance Vendor

    Anyone have a book that will tell the stock track width on the front axle of a '49-'55E and a '55L to '58 Chevy/GMC truck?
     
  2. HotRodChassis
    Joined: Jan 23, 2005
    Posts: 2,283

    HotRodChassis
    Alliance Vendor

    I'm not a member over there. I did a search, but it mainly just talked about IFS track widths and S10 frames.
     
  3. HotRodChassis
    Joined: Jan 23, 2005
    Posts: 2,283

    HotRodChassis
    Alliance Vendor

    back to the top for a helping hand
     
    Register now to get rid of these ads!

  4. Torkwrench
    Joined: Jan 28, 2005
    Posts: 2,393

    Torkwrench
    Member

    I didn't see the wheel track listed, but Nostalgia Sid's Dropped Axels, www.droppedaxles.com listed kingpin to kingpin widths, and spring to spring widths, and some other measurements, if that will help.
     
  5. Snarl
    Joined: Feb 16, 2007
    Posts: 1,640

    Snarl
    Member

    I have a book that lists track widths, but I'm at work right now. I can look into it this evening and get back to you.
     
  6. Snarl
    Joined: Feb 16, 2007
    Posts: 1,640

    Snarl
    Member

    47-55 1st is 57.6" front, 60" rear

    55-59 is 60.5" front, 61" rear

    This is per the "Standard Catalog of American Light Duty Trucks" by Krause Publications
     
  7. Anyone have to total specs on a 1952 3100 chevrolet pickup rearend? i mean housing fron inner flange,drum width and wheel mounting surface to surface. Is the 4x4 S-10 still the one to go to?thanks
     
  8. Dreamweaver
    Joined: Feb 26, 2003
    Posts: 1,015

    Dreamweaver
    Member

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.