Register now to get rid of these ads!

'33 willys sedan build

Discussion in 'The Hokey Ass Message Board' started by jan bogert, Dec 27, 2012.

  1. jan bogert
    Joined: Jul 11, 2011
    Posts: 655

    jan bogert
    Member

    hi, starting on my '33 willys sedan. yesterday i got the rad. & e/fan installed. motor fresh not fired yet. tomarow, and the weekend, i want to fab brackets for the mini alt. here r pics. of the radiator install, i used model a brake rods for the top grille rods to the firewall. monday i should have pics. of the alt. install. and then so on, so on. the way i knock my cars out it shouldn't be to long before its done. my AV8 went from a field find to finnished in about nine months. and they don't leave the toy box for anything and i mean anything.:)
     

    Attached Files:

  2. lawman
    Joined: Sep 19, 2006
    Posts: 2,665

    lawman
    Member

    Nice start. Please keep posting.
     
  3. Looking good, What are those exhaust manifolds from?
     
  4. jan bogert
    Joined: Jul 11, 2011
    Posts: 655

    jan bogert
    Member

    they're Sanderson cast headers big $.
     

  5. they look it!!!! :D I think they look nice with the rest of the engine.
     
  6. Fat Hack
    Joined: Nov 30, 2002
    Posts: 7,709

    Fat Hack
    Member
    from Detroit

    33 Willys are THE Willys in my book...hope to see more of this one!!
     
  7. violet springs
    Joined: Apr 2, 2006
    Posts: 389

    violet springs
    Member

    Looks good, how about some pics of the whole car?
     
  8. jan bogert
    Joined: Jul 11, 2011
    Posts: 655

    jan bogert
    Member

    ok, here u go mustang 2 front end, 394 posi s10 rear th 350 with shift kit and of coarse the '70 350 4 bolt, .030 over flat tops, comp. cam, 202 heads sanderson headers.
     

    Attached Files:

  9. jan bogert
    Joined: Jul 11, 2011
    Posts: 655

    jan bogert
    Member

    today i fabed alt. brackets. now i'm looking at the lower radiator outlet. the outlet over shoots the electric water pump outlet. i need to cut 3/4 to 1 inch off and that means i'm going to loose the flange. is there somewhere were i can get that reflanged? that is a seal right?
     
  10. Jalopy Joker
    Joined: Sep 3, 2006
    Posts: 28,608

    Jalopy Joker
    Member

    Kool project - 3:94 gears with a 350 trans?
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.