Register now to get rid of these ads!

Customs 1960 FB Holden Wagon update

Discussion in 'The Hokey Ass Message Board' started by ceegrey, Sep 7, 2011.

  1. ceegrey
    Joined: Sep 26, 2008
    Posts: 93

    ceegrey
    Member

    A good day at the engineers on Monday, the roof chop, chassis mods and engine fit up were signed off on. The mounts for the Chrysler torsion bar front suspension are in place and we will begin the task of fabricating [​IMG]2 half door skins, one complete near side front door skin and the radiator frame over the next couple of weeks. Progress will speed up a little now [​IMG]the major part of the work is out of the way.
     
  2. ceegrey
    Joined: Sep 26, 2008
    Posts: 93

    ceegrey
    Member

    More photos on my album
     
  3. belair57
    Joined: Dec 4, 2007
    Posts: 84

    belair57
    Member
    from australia

    gday ceegrey. Looking good, what donk are you going to use.
     

  4. Hey, your photo is upside down.
    Is that because you are down under.

    Cheers from across the ditch.:D
     

  5. autobilly
    Joined: May 23, 2007
    Posts: 3,094

    autobilly
    Member

    He's going to run "a warm 360 ci Chrysler small block".
     
  6. zapp69
    Joined: Sep 30, 2007
    Posts: 342

    zapp69
    Member

    Sounds like an interesting project.
    for the guys not familiar a stock FB Wagon looks like this
    [​IMG]
     
  7. damagedduck
    Joined: Jun 16, 2011
    Posts: 2,342

    damagedduck
    Member
    from Greeley Co


    i'm not quite sure why BUT i think i like it:eek:,but i would have to lower it..:rolleyes:
     
  8. ceegrey
    Joined: Sep 26, 2008
    Posts: 93

    ceegrey
    Member

    The engine fit up is a small block Chrysler/Dodge 360 hooked to a 727 Chrysler transmission and Ford rear end lifted from an Aussie built Ford XR8. All of the mounts to hang a Chrysler torsion bar are in place, we will use genuine fan belts etc also
    [​IMG][​IMG]
     
  9. damagedduck
    Joined: Jun 16, 2011
    Posts: 2,342

    damagedduck
    Member
    from Greeley Co

    jeez that thing is gonna be mean!
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.