Register now to get rid of these ads!

1954' Chevy 3800, Ex cab, 7 window 1 ton Dually

Discussion in 'Cars For Sale' started by Rustahaulic, Aug 21, 2014.

  1. City: Nashville

    State: Tennessee
    Price: $10,000.00
    624803_3.jpg
    Reluctantly considering selling my 1954 3800 Custom extra-cab 1 ton dually...
    This is a PROJECT but it is a start, run, drive, stop vehicle, needs very little to finish...There is a ton of fabrication time in creating this seemingly stock looking truck...I bought and was going to build it as my hauler for my hotrods and make it my Shop-Truck, but sometimes life has a way of changing your plans mid-stream...
    (the 3800 was only ever available in a single cab flat bed or cab and chassis)
    No extended cab or stepside ever exsisted, so

    I will get a partial list of it now and come back this evening and EDIT the list because its A LOT!
    Rust Free 2 owner (same county) Oregon truck, till 3 months ago...
    Custom Fab extended cab , stock 3800 frame, custom fab stepside bed,
    New 455 Buick and Built 400TH trans, 4:10 gear

    (this rear gear needs to change unless you're logging or just pulling over houses),

    68/69 cadillac tilt n telescoping column n wheel,
    Aluminum Dash, New VDO guages, 17miles,
    Jeep commanche bucket seats,
    Genie Shifter,
    Power steering,
    Vintage A/C,
    New power window kits, (not installed)

    Have all glass except extra cab side-glass, nice original corner glasses
    (factory green) just needs flat glass needs to be cut, ($35 a side was a quote
    windshield is original but fully usable, door glass is intact but tinted..
    My buddy quoted me $75 flat safety glass to fit and install at my place) window tracks are there in ex cab holes if you wanted them to roll up and down...
    There is SO MUCH to this truck, it's hard for me to remember it all.
    Shoot me a message or (calling or texting may get a faster response)
    6152393899, if you have any questions...
    $10,000.00 Ca$h price
    I have original clear Oregon title In-hand.
    I may be into partial trades, but it also has to run...
    Many parts not in pics are included just didnt feel the need to put them on to have to take them off when I was about to primer and sealed the body.
    *Nothing that eats (the dog doesnt like the competition*
    624803_2.jpg 624803_8.jpg 624803_4.jpg
    624803_1.jpg 624803_6.jpg 624803_5-1.jpg

    apparently my pics are too big so I am gonna have to resize them to get them on here...You're a sharp bunch, you get the idea I'm sure...
     

    Attached Files:

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2020 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.