Projects 1933 dodge coupe "Baleful"

Got some work done, today...only had about an hour but managed to get the crusty cowl out and the replacement in!

 

If you are interested if have 2 partial door tops for 34 and could use 33 plymouth/dodge. They have some small holes but nothing like what I see in yours

 

Yeah! I need a top for my drivers door, steve has one for me but itd be a shame to cut up a mostly sold door

 

Very Cool fellow Dodge Brother!

 

Thanks!

 

You can pm me if you'd like. [email protected]. You can have them just pay some shopping. Hopefully they will help a little

 

Very much appreciated! Definitely on a tight budget. Thank you

 

4 1/4" is how thick or tall the frame is above the axle

 

Had to come back out and do the drivers side or id never get to sleep tonight...

 

Don't tell anyone but I love the Ram in the background too.

 

Short bed 4 speed! Going to be up for sale before too long!

 

Thanks Oliver, but I need the measurement of the difference between the top of the frame where the body goes ,and the lower parts ot where you measured, difference from the top and bottom,I nèd to make a frame ,so I need to know that measurement.Thanks again.

 

Ohh okay, ill get those for you tomorrow

 

Hey! Your thread got Featured! Congrats!

Dave

 

Thanks, I dont know what that means? Featured where?

 

Look up on top on the right side, you will see the Featured banner.

Dave

 

BTW, my wife and I can't believe how much your son in your avatar looks like our grandson about 6 years ago!

Dave

 

Oh cool! Haha thats neat, he loves cars and car shows! I did almost cry a little during the junction city cruise when he said his favorite car was the goofy tuner with a huge wing on the back....kids...

 

If I'm reading right, woodie wants this, height from flat section of frame to height at top of kickup over front axle or bottom of kickup.

 

Yes that's correct, the lower line measurement ,whether it's level,or higher or lower,thanks Rods and Race,the pictures is easier then words.

 

Top of the frame, where the body would sit, to the bottom of the raise section over the axle.

 

Ill get it tomorrow, sorry had a full day with the family and didnt get out to the shop

 

i cut my teeth on rusty cars..on the winshield post , cut out a section in the back and reinforce the post....i dont see rosette welds any where,,,welding the outside perimeter is not good enough.....nice effort...had a 33 many moons ago.....

 

I was going to weld reinforcements in the channel the wood goes over, figured besides putting it inside the pillar that was the next best place to hide em. Thats where the plug welds will hide! At least by my plan

 

The frame rises 1 3/4 inch

 

The highest point is actually in front of the axle as well, 1 3/4" over axle 2 1/4" at its highest