I have decided to list for sale my pride and joy. Original full fendered Henry steel 1930 Model A Tudor sedan, brand new frame and suspension, with a SBC 383 Stroker with a 671 blower. Very clean and straight body. It is hard to source an all original body in this condition, that isn't an all original car. The parts are all brand new in the box, receipts for most everything can be provided to the buyer. The engine was primed and I turn it over by hand every few months. Never been started, brand new. Specifically I have the itemized list of the engine build I can send, along with other receipts. Below is a list of everything for sale: Engine: $6131.78 383 Stroker/Blower engine build includes DART aluminum heads, full hydraulic roller rocker assembly, ARP connecting hardware, bore, hone, balance, assemble (receipt available if you wish to see it) $739.99 Eagle crank forged 4340 383 stroker $460 SCAT forged H beam connecting rods w/ ARP cap screws $3500 671 supercharger kit - polished $725 MSD 6AL-2 ignition control kit $895 Dual Holley 650cfm in line silver blower carbs $125 Summit high volume polished water pump with billet pulley $250 4 bolt main 3970010 high nickel, high strength engine block $300 (2) 700r4 transmissions (can't have too many with this engine) $52.12 SBC flywheel $219.99 Champion 3 row/core Aluminum Performance radiator, made to fit 32 grill shell $97.99 Chrome high torque mini starter $75 Chrome high performance alternator Chassis: $3200 HEIDTS Superide II Independent Front Suspension, Willwood Calipers/Rotors, Flaming River Rack & Pinion $750 Brookville Roadster frame (w/ install of HEIDTS IFS front end) -$69 rear coilover mounts -$89 install SBC engine mounts -$110 700r4 transmission mount bracket $199.99 Adjustable rear coilover $198.95 Triangulated 4 link rear suspension $159 7" Power Brake Booster/master cylinder, pedal, frame mount $50.60 Adjustable brake proportioning valve and residual flow valves $300 Wheels/(4) new tires, ~13" wide rear Mickey Thompson N50 tires $350 Ford 9" rear end and pig $370 MOSER Engineering 31 spline axles -$100 MOSER bearings -$300 MOSER housing narrow -$350 MOSER rear brake kit $398 16 gallon extra capacity steel fuel tank Body: (photo shows original body with included fenders on) $3000 Full Fendered Henry steel 1930 Model A Tudor sedan $600 Exterior body/fender media blast, seal, prime $200 deep inset mini tub fender well inserts $269.99 1932 Ford steel grill shell and polished stainless insert $250 Stainless polished drop headlight bar $644.40 Classic Instruments Vintage 6 gauge set Body comes with all 4 fenders, hood, cowls, front folding seats, and rear bench seat. They are all original. Seats need upholstered. Extras: $132.68 Speedway polished valve covers $150 Electronic distributor/ignition $100 Engine stand, you can have it $25,913.48 TOTAL That said, everything listed goes with this vehicle and is specific to it, so I don't want to part it out. If I were to sell individual parts, I'd be left to re-buy them if I ever started on the project again. That said, it's a package deal. This engine is a monster, and once it's rolling down the street will be a blast. The car comes with a clean and clear Indiana Title. It is titled as a 1930 Ford Sedan. Looking for cash, asking $17,500, make me a reasonable offer. Call or text at 260.205.1263
The Jalopy Journal
