The Jalopy Journal
I have a conundrum! I ordered an oil pan gasket from Speedway for what I thought was a '77 350. When I took off the pan and old gasket, and then...
Hello everybody, I'm new to the ham. This is my first time I've ever made an account even though I've been reading on it for years. Anyways, I'm...
Hey all, I've been watching these forums from afar for quite some time! There's so much great knowledge here amongst everyone and it gives me hope...
Hi guys, Like many before me, I have a leaking rear main seal in a 350 SBC... It's a "Hencho en Mexico" 350 Blueprint motor bought and fitted by...
I’m rebuilding a Sbc in my buddies 1954 Ford F100 . It keeps blowing out water pump gaskets . It literally disintegrates the gasket after 10min of...
This is my 63 Rambler build. When I bought it, it had no engine or trans. My Dad has a Chevy 327 that's going to go in it and my Papa has a trans...
Wanted to ask y’all about using blocks that have threw a rod, has damage on bottom of 2 cylinders real good all together 4. It’s below the ring...
Hey all, I'm relatively new to posting things on the HAMB but I feel that I am out of my depth with my current chevy 350 build. About 2 years ago...
Ok. A little back ground. 1955 Chrysler with Stock 350 small block Chevy motor. TH400 trans. Edlebrock 600cfm carb. HEI distributor. All new...
I have a stock bottom end 350 with new bearings, gapped rings, and a high volume oil pump. I'm putting lt1 aluminum heads on it with a static...
I'm currently toying with the idea of creating an intentional vacuum leak to get around a carb CFM rule. Basically limited to a stock reproduction...
Guys! New to the site and working on rebuilding a chopped 1951 Chevy Styleline. I have already installed an XJ6 IFS and rear disc brakes on 1958...
sold
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] This is a 1977 Chevrolet Corvette engine it is complete minus a intake. It is standard bore, rods and...
Im in the process of completing a chevy 350, mostly stock, for a model A coupe. The motor is pretty low key and will make around 250hp. I have a...
Separate names with a comma.