The Jalopy Journal
Bottom Line. The distributor was defective. It was returned to vendor. I opted ato use a PerTronix Ignitor for Ford 8 Cylinder. Runs beter than...
whoa. That makes sense now that you write it out M.O.N. After tonights basball game I will bench the carb and go through my valves. Oh and my...
I installed it and the o-ring is too small I am going to have to find a larger one if I can - because the distributor is wobling back and forth at...
Wow that is an awesome diagram thank you
:confused: logride did you have to change your advance springs or make any adjustments after your install?
"You will need some kind of ignition module." it is on the underside of the distributor. It is HEI.
Cerebus, In my day we would say that motor is TOUGH.
I just have these questions because I can not find and did not get instructions.
ford 302 knockoff brand ebay.
let me get an answer on this kind of wiring for this particular distrubtor. I know I have to use a coil. 1st question do both wires conect to...
Thanks for the help. I and I was able to replace my diz.
I waited until I got my distribuotr OEM replacement before I proceeded. I took all the parts off and out. Tapped it side to side where the vacuum...
I had this thing checked and it is worn out, lets hope all of the advice helps to pull it up and out.
Better to find out before I tear it out.Thanks. I sure can count on the HAMB members.
I need to know if the Ford 1970 302 and the 351W Distributors are the same, are they interchangeable?
I really do not want to take it out. I just need to adjust / set timming. I have not checked it again, today.
Do you mean Liquid Wrench type oil?
I am hoping not to go full gorilla. If the WD40 does not work I will try vinegar. Worse case is I think the motor is a hair out of timing. I am...
I have it soaked with carb cleaner. I tapped with with my rubber hammer. NO GO... I thought it best to get some hamb help before a gorilla it....
I loosened the hold down bolt at the base of my 70 ford 302 and the distributor will not turn left or right. Stuck. I can use some advice.
Thank you. I really can complicate a simple electrical plan.
Thank you. I see now that I should conect it to the IGN. side of the keyed switch. I am understanding this correctly?
I have question for the hammers. Please help me. I have been told > Just connect it to a + postive power source and all is good. Does it connect...
I use a wire brush and I use power wire wheels. I don't put them in cups or bags but, I could. I use them wrapped with eletric tape.
finest floor and firewall I have seen
After reading this link. I will use it. I got stuff to paint.
burn this thread, go ahead, please. This is Jalopy Journal not funny photos.com.
You got GAME!
Today, I have purchased the strap for motor to Frame. The 12V battery is under the seat, in a box with the Negative grounded to the all metal...
The solenoid is grounded and starter motor is attached to the block and has only one wire going to it from the solenoid. So how do I ground the...
Separate names with a comma.