The Jalopy Journal
Does anyone have a 1955 Olds #8 cylinder head that they can measure to give me the dimensions of the intake ports from ( Height and Width). I have...
I have a 1949 303 Olds motor that came with the original 6 volt starter. I will be wiring my project car for 12 volt. I understand that the 6 volt...
Found this video on You-Tube. Interesting test setup, what do you guys think. [MEDIA]
I'm considering using a Pertronix ignition module in my 1949 303 Olds motor. I have a later model distributor (#1110824 3L4) from a 1954 324...
I am looking at using three Stromberg 97 carbs on an Edelbrock 396 intake on a 303 Oldsmobile. I will be using a progressive linkage where the...
I ran into a problem with clearance for the fuel supply and return lines at the gas tank on my 32 Ford coupe project. I have a Brookville coupe...
I got the gas tank installed in a chassis from Brookville Roadster. I'll be making my own rear spreader bar so I used a scrap piece of 2" dia....
I'm working on installing a Winters quick change rear in a Brookville 32 coupe frame. I'm using coil over shocks and ladder bars. I set the frame...
I'm getting ready to finish up on the front end install on my Brookville coupe project. I need to know how to locate the rear mounts on the radius...
I need advice from anyone familiar with putting a 303 Olds motor in a 32 Ford 3 window coupe. Here is the motor with an adapter from Ross Racing...
We've all been watching Flop's threads on how a master metalworker chops a 32 three window coupe, this thread will show how an amateur learns how...
I have a 303 Olds that has a Speed Gems pilot bearing adapter in the crankshaft. I bought a trans adapter from Ross Racing to mount a T5...
Picked up a Brookville coupe and frame at Fall Carlisle and ordered a flat firewall for it. I understand that the body was lowered over the...
I have a Sun Super Tach Model SST-802-2 that I can't get to work. It blows the fuse on whichever circuit that the 12 volt ignition terminal is...
I have a 55 Chevy with a 57 Olds rear in it. I ordered a drive shaft for it that comes with 1350 U-joints. What conversion U-joint do I need to...
Hello everyone, time for me to introduce myself. First I would like to thank everyone for sharing all their great info on this site. I've found...
Separate names with a comma.