The Jalopy Journal
Morris or Morris-Commerical
I am trying to find con rods 7.25 inches long to fit a 2.25 crankshaft and an inch wide at the big end the wrist pin size is not important. Thanks...
Detail of Mumford Link
Maybe consider a Mumford Link it only attaches to the ends of the axle tube and gives a nice low roll center
Jaguar MK11 cantilever rear suspension the front half of the springs mount inside the chassis rails a bit smoother than 1/4 ellipticals due to...
Not 3350hp but 3800hp
You might take a look mercedes W196 & 300SLR from the early fifties, they were one of the last high performance straight eight engines and they...
Maybe a blown headgasket between 1 and 2
Yes to all of the above plus seven pounds of boost
Is there much advantage in running the first dual point crab distributor 1940-42 over the later 1942-47 single point crab distributor, i e is the...
Btt
Are there any 5 lug on 6 inch PCD 16 inch wheels, I was told that some mid 30s GM had them but I cant find any reference to them
The dual point and single point photos
Will the later type single points, flat side clips, distributor cap fit on the earlier twin points over the top wire clip distributor body
Have there been any recent F head conversions for the A & B blocks, In the 1950s Elva Willment & LRG did them for 72 cubic inch baby B block in...
Separate names with a comma.