The Jalopy Journal
The way that one of the Pay Pal scams works is, A) The guy ask you for a payment request, B) You send it, he pays it with his credit card, but ask...
Hey thanks everyone for the quick wiring lesson. I think I can sit down now and figure out what I need and start shopping around.
So the main engine/computer control system should be almost a stand alone system. I mainly need to supply the proper power as you described. The...
I am not planning on power windows or many up grades, just the engine and trans with the fuel injection etc. I am just concerned with all the...
Looking for any directions that may help in my project. 59 chevy truck with a 99 gm 350 and trans. Anyone know of any good information on this...
I have a 45/46/47 Ford Pick up and would like to find the ID number on the frame. Does anyone know where it is located? Is it in more than one...
Do the Ford F1 and F2 trucks use the same front fenders, hoods and doors? I know the beds are different. Thanks
Thanks for all the info. First time I have owned a Y block.
Did a search but could not find an answer. Is there any differences in the 4 barrel intakes for the 50's Y blocks, to the 60's Y blocks? I have a...
Check with Pep Boys. When I was running 13's, they had a good selection.
Thanks Muttley, I will give them a call. I would prefer quality over cheap anyway. Any other favorites here in the area?
Hey guy. Can someone point me to a good engine builder in the Fresno or Visalia area? I am looking for someone with a good rep that builds...
Thanks, it did come with a frame, so I will see if there is a readable number and try that route first.
Hey any of you guys here in CA, I need some advice for a title. I picked up a 30/31 Ford A that I am going to build a simple bucket type...
Once I,m moving, and the noise starts, it stays pretty constant reguardless of which gear or amount of gas/acceleration being applied. I am...
Hey, I have a 64 F100 with a 4 speed. I have a noise that is coming from either the trans or the rear end. What is the best way to determine...
Dinuba is south east of Fresno
Thank You
Can someone give me directions to Turlock Swap meet. I will be going north bound on 99 and need to know what exit to take. Thanks Gerry
:eek: You mean there is a Home Page?:eek:
I have had this problem. found 2 possible causes. 1) Depending on the spool of wire that you have on the machine, there are different way they...
Hey, thanks for all the great info. Thinking of doing something a little different. Gerry
I need to tap your vasy knowledge. During the 60's, GM had a 4 cyl engine that came in the chevy II/Nova's. Can you tell me what size that...
Did the spin on adapter have a seal that went in the center? I had a problem once with a 327 where a spin on adapter had a soft seal in the center...
After I lost my job as quality control inspector at the Mustang Ranch, I became a tech in the exciting world of air conditioning and refrigeration...
Thanks for the input. Gerry
This is a single carb, two inlet type. Don't know original color, it has been blasted and primered.
Hey, looking for your opinions on a Cad air filter that I was offered. Need to know what you think is a fair market price. Housing in in great...
Can someone in CA tell me when the Turlock Swap Meet is? ThanksGerry
Hey, guys, thanks for the info. I didn't want to have a small fortune into the truck and find out that it could not be registered. Thanks!!!!!!
Separate names with a comma.