The Jalopy Journal
Andy, email [email protected]. He's a wizard with 292's. he has billet mounts for 'em. Keepin' 'em inline since '53 Buffalotrux
You should consider 2'X6" wall studs for insulation capacity. I sealed the insulation with 4 mil plastic and use peg board for the interior wall...
I would suggest two story for the storage. My ceiling is 10' on the first floor. 2' joist in ceiling supports 5/4 decking for second floor. 2"X6"...
The temp sensor is about half way back on the left cylinder head on a 4.3. If the thermostat is stuck open this would also cause the code to be...
First, what kind of car are we discussing. A 6V system run with 12V could have some damage. If you ground the gas gauge wire from the dash unit to...
What carb are you running? The Rochester Model B has a snatch idle circuit that feeds fuel across the top of the throttle bore and down the...
'47 Ford tail lights in the rear cross sill look cool. Buffalotrux Keepin' em inline since '53
For what its worth, you can use a small cresent wrench to measure the thickness of a piece of metal. Then wrap a small piece of duct tape around...
Caddo Mills was the first drag strip to have a 200 MPH side by side race. The Chitown Hustler( first 200+mph dragster and The Scorpion. Chris...
First you need to check the available voltage and amps at the dash lights with a digital volt ohm meter. Then check voltage and amps output from...
Howdy Y'all I'm new to H.A.M.B. Been building rads since '53. Currently working on a '66C-10 SWB stepside and a '54 AD pickup.
The '83 T5 has a 4.03:1 1st gear. The '86 T5 has a 3.76 1st gear. That is the highest ('86) 1st gear ratio. You will need a six cylinder bell...
Take a look at Day Motor Sports on line. They have a great selection of springs. Buffalotrux
Hello, I'm new to H.A.M.B. I'm an old fart with a past. I built my first hot rod in 1953. It was a '29 model A roadster on '32 rails. It had an...
Separate names with a comma.
The Jalopy Journal