The Jalopy Journal
bump
RARE!
1 Pair of used CanAm gm big block magnesium valve covers in nice condition. Extremely light and Rare
How do you delete conversations?
Thanks everyone for the compliment on my bumperdesign
What do you think of the ART DECO style bumper that I created for my T?
Nice fab work
This is a 1928 Whippet rad shell in usable condition. Surface rust with some pits and will need some repair on the on the bottom. Good alternative...
This is a Yankee 960 signal switch in good usable condition just needs cleaning up. Nice ART DECO design for nostalgia rod or what have you.[ATTACH]
yankee 960 signal switch
This is a Yankee 960 signal switch in good usable condition. Just needs cleaning up . I can ship just give me full name and address and phone...
This is a used YANKEE 960 signal switch . Needs cleaning up but is free to operate. All complete inside and just needs cleaning. I can ship just...
could you make 8 of these cones for me to fit my sbc flange kit Thanks John 905-263-2737
Does anyone know how to install a T5 transmission in a stock 1932 Ford(B engine 4 cyl) without cutting the "K" member? Are there any t5...
You have to be kidding?
Does the 40 plus air pressure make it ride lke a brick shithouse?
They should be paying each car owner entering the show a token $100.00 to have the honour of having their car at the show. Show a little more...
Beautiful Stuff!
The car looks great Larry. John Boy
I am in the proces of putting an S10 (mechanical speedometer) tailhousing ,on a Mustang T5 (1985 #1352-126). I have kept the oiling funnel for the...
Did you find out what to do with the bearing and race? I have the same question.
I will be there with "VONDUTCH"[ATTACH]
The oil flinger in the s10 tailshaft (wc) will not fit into the nwc t5 camaro tranny that I am trying to install it on.They are two different...
How much for the 10 inch disc. I want to use it with the 10" flathead flywheel,pressure plate etc.The transmission is T5 S10. The input spline is...
Could you mail me one of the Flathead Cam Timing gear Lockplates? John Walton...
Never met him personally but I always admired his workmanship. What a shame to lose such a quality person. My deepest sympathy to his family....
Separate names with a comma.