The Jalopy Journal
Even though it`s getting more difficult to do a lot of what I enjoy doing.My project is a 48 f1 Ford roadster pu with a 440 -tq flite and 9 inch...
Find a good quality small right angle drill ,sander, air drive and some 4 inch buffing pads and arbor.Easy to handle and does a great job.:D
Unless you are fluent in flatheads and have a ck book with a lot of big numbers in the balance colum.I recommend the sbc and a 4bbl of your...
Make sure you are getting a full 12 volts at the distributor.Voltage drops as they get hot. hope it helps.:D
Hamb name is Too ManyTo Count :D
You are on the wrong track.Builders Hamb name is "Too many to count":D
Dual duce intake and carbs for 34 Ford 85 hp
All I can contribute is some standard shift and automatic transmissions use different starter drives.:D
"Look up" too many to count" Last I seen of it was an early 50`s suburban with a 500 Caddy :D
If it has a vacuum modulator,it may have failed or the hose has come off.:D
Make sure the secondaries are closing all the way.:D
Now that you have it out try dry ice on the crank and heat the balancer with a hair drier.:D
iF YOU OR SOMEONE ELSE IS GOOD WITH A MIG,SLOWLY BUILD UP A PILE OF WELD UNTILL ITSTICKS BEYOND THE CRANK SNOUT.After it cools take a pair of...
Tip may be worn .You might need to remove the wire all the way from the spool.Liner may be a suspect as well.:D
Go to fordifacation.com makes ID a snap.:D
I believe this repair would be a viable option.Watch the video and judge for your self.:D
CK your brake pedal geometry.Sounds like you need more travel at the pushrod.I have ran into this problem more than once.:D
For reference only,my 48 had a spring clip that slide in a groove on the lock cyl.Access was thru the inside door panel. 39`s may be different...
Welcome to the HAMB and rodding,sounds like my one time problem,too many projects and not enough MONEY .No,I didn`t find a bunch of money.I paired...
Cant help myself,Buy the shoes,the box is free.:rolleyes:
SBC with 30-30 Duntov from idle to 8 grand or so.Forgot, open headers.:D
I have been on and enjoyed most of my shakedown runs,in fact I just did one today.Never had one strand me ,but I did have to clean a fuel filter...
Shouldn`t the valves be rotating if the geometry is correct?:confused:
Welcome from Carrollton.:D
This is a very likely suspect,it`s the only thing you really changed.:D
I dont remember the name of the car but I had a bubbletop 58 Chevy parked in my garage overnite.It was supposed to have been built by George...
Good advise.:D
Replacement parts are available,and parts carbs are cheap.I suggest downloading "Servicing the carter aluminum four barrel carburetor" at...
Make sure you are getting a full 12 volts at the coil when cranking,HEI`s are funny that way. :D
I recommend the 135 220 model,I`ve had good luck with mine for 15years now. Practice a lot and watch out for cold welds.Penetration is :good if...
Separate names with a comma.