The Jalopy Journal
I should also mention that most of what I've used it for is edging parts, interior stuff, and small spot repairs. I don't think I would risk...
I've used their clear over Shop Line base coat. Makes for an inexpensive, fast drying and easy to work with system, seems to hold up as well as...
bump
Thanks guys, but it has to be a '59 or '60, '61 and up has the lower pulley welded to the frame. Earlier cars have it bolted to the floor roughly...
Here it is from the top side. Almost no rust, original paint. '67 325 horse 396 under the hood, close ratio Muncie, 3.70's with Positraction out back.
This is what I'm talking about.
I have a '60 Bel Air that the floor pans were replaced in, and the roller for the parking brake cable that goes somewhere on the driver's side...
they're pretty nice, but I just love that T-Bird-lookin' top on the sedans
I have a '60 Galaxie two door post that I am considering building for daily use. The car has a very good running 292 and Cruise-O-Matic. I drove...
Back when I started doing bodywork in the mid '90's, I frequently used PPG DBU basecoat and would clear over it with either their DCA468 lacquer...
Lookin' for lower quarter panel moldings for my '60 Galaxie two door post. These are the ones in the middle of the panel, not the ones along the...
it looks to me like its coming from both ends. the heat riser is tied wide open, and the carb doesnt seem like its excessively hot. as far as the...
My '63 Impala has a 327 with a stock 4GC on it. It runs fine, but when i shut the car off, fuel pours down the inside of the carb and floods the...
Separate names with a comma.