The Jalopy Journal
Went to the NHRA breakfast at SEMA last Nov. Snake and the Goose were there to talk about it and answer questions, along with the director and...
In my roadster with 392 Hemi bored to 407ci, TH350 tranny I used a 9" with 31 spline Moser axles and a Detroit True Trac center. Hooks up, goes...
Anyone going to the Woodward Dream Cruise that needs 1 parking pass for Saturday? All of a sudden I can't go this year (been there for 13...
Gotta make notes on you guys that are going, so I can look ya up. Say hi if you see me by my 29 Hemi Roadster. Had to cancel 1 room at the Bryce...
Late reply, but here's what I did. Took the little rod out and tapped the hole for a pipe plug. I did hook up the vacuum line. With the torque...
60's into 70's, Washington Rd. now Rostraver Rd./rt.201 in Belle Vernon, PA. Had 2 - car hop drive-ins, Stringhill's to The Dog House, 1/4 mi...
Glad to see you joined, most people don't listen to me. LOL Was good to talk with you at the show. Now that you added a pic it'll be easier to...
Thanks for the reply. Took short block to Rodlands for him to look over. Easy to talk to, now awaiting his opinion on what all needs done.
Does anyone have any experience with either of these shops located in the State College, Pa. area? Rodlands Crankshaft Grinding or Shady Dell...
Thanks Hambers, Lots of good input. The trannys still sitting on the floor. Going to pull the pan to install a bung in it for a temp gauge, so I...
Yes I'm sure. The Hemi's punched out to 407 cubes and will make some serious power, in a 2300lb car, sure won't need a passing gear. So I'd...
Thanks so far for replies. The TCI tranny is a Auto that can be manually shifted, but not a manual only valve body. My others always had...
Hey gang, Building my first Auto/Manual shift car, TCI TH350 streetfighter trans w/ratchet shifter in a '29 Model A Lowboy w/392 Hemi. Sure...
392 (.060 over) going in a '29 A Roadster. 354 truck waiting to revived.
Hey Hambers, Going to replace the entire flywheel/clutch on my '32 Chevy street rod. Running a 350 sbc with a M-20 Muncie & 9" 3.50 rear. dyno'd...
Thanks spoons. Cruze on.
Here's what I have for you from the first post, I see now that you asked for more when I logged on. Will try to get those for you tomorrow. I'm...
Wanted I need One 392 .010" Clevite 77 Main Bearing for a middle journal, not a thrust or rear bearing. Anyone have one or a partial set? The...
Separate names with a comma.