The Jalopy Journal
Hind site is always 20/20. I didn't think the carb change had any impact on the shift points for the transmission. I am use to the 350 turbo...
Well I am glad to report the transmission slip is fixed. Turns out that the kick down leaver does more than just put the transmission into...
I just talked to Lucas Oil tech support and they recommend using the Transmission Fix or Conditioner for this problem, but do not use their...
I have verified that all linkages are working properly. I have been reading about the Lucas Oil Transmission Fix product and think it might be...
Thanks everyone for the insights and suggestions about my transmission issues. This is the first older automatic transmission I have worked on so...
Yes I replaced the flat seal and the o ring on the throttle shaft all washers and pins properly installed. No leaks . All linkages are properly...
Thanks for the suggestion of Old Car Manual Project. I will look that up. It has been suggested to use type F ATF because it is thicker, would...
I am including a picture of the gear indicator on the dash. The only things I done were change both pan gaskets and the shifter shaft seals....
It is slipping at each gear change. 1st to second is the worst. Drives fine after it finds the gear. It is a three speed transmission.
I have an all orginal 55 olds super 88 rocket. I just replaced all external seals and gaskets on the transmission. Prior to the reseal the...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
[ATTACH] [ATTACH] [ATTACH] [ATTACH] This truck was originally from southern Georgia and was never subjected to winter road salts. The body is...
That makes a lot of sense. I would imagine shipping would be expensive for a complete set.
My 31 tudor project has finally arrived at the stage of needing window glass. Does anyone on the HAMB custom cut glass or know where I could buy...
Here are some pictures of my tank in process and installed. I'm going to add the vent to the fill tube and install a roll over valve.
Thanks for the feedback. It only makes sense that it would need a vent but I have seen several people that didn't vent their tank. They must be...
I have made a custom gas tank for my 31 Tudor Sedan out of 1/8" sheet aluminum that fits between the frame rails at the "Z"ed portion of the rear...
Separate names with a comma.