The Jalopy Journal
This is a pic from this site of a 40 PU, very different with a smooth transition thru the firewall that my made me question, along with the need...
Appreciate it! A little shimming and good to go.
would make a sharp bend in the cable. Anyone have pics or a drawing of the dash? Am I missing brackets? Thanks
Trying to use the 40 handle in a car with replaced cowl and floors, looks like one end bolts at top of dash and the other bolts up against the...
1940rpu, I started a conversation with you to see your cars.
olscrounger and X38, great looking cars, what kind of suspensions are you running? To your points I suspect the springs, whatever they are, are...
How much did you guys say an Art Morrison frame costs? :mad:
Kinda hard to see but the front mount is at the juncture of the frame and the X member, possibly the spring is too long? I swapped out a Blazer...
[ATTACH]
OK, that's the right wheel in the center of the opening, other than tire rubs that's what I'm trying to get to.
[ATTACH] [ATTACH]
Saints be praised! I had to reduce the size of my pics. Thank you mod! This is with the 255/60's with 2" lowering blocks. Next, thought I had a...
Don't I wish, each time I try to post a pic from my laptop I get an error message saying it's a security issue, reload and try again which doesn't...
I can't get anything past you guys, I fat fingered my phone, I've tried my (27") 205/60/15's from the front and they're a big improvement. The...
Recently I've tried to add pics to my thread, all good until the upload is terminated with the message: The following error occurred Security...
Need to lower the rear, with 24" tires the fender opening is 3" over the tire riding on 2" blocks. 80's S10/Blazer leafs, measured along the main...
I'm back at this after some family care (senior) problems... So plumbed every position, frame/axles spot on, body is off some amount, but as Darin...
I gotta move on before this car kills me. I'm going to start with a 4 wheel alignment and then replace the rear springs which sit too high,...
I can get a pic on this reply and then Hamb gives me a "security error" message and removes it? [IMG] I didn't describe this correctly, my bad....
I've plumbed and measured front/back/diag, cross member, axle, known holes, this frame had to be welded on a jig to be this accurate. Real axle is...
The axles are spaced perfectly, hate to change that? I've changed all the mechanicals, put a Comet 8" in, don't know what the leafs are from. Have...
Bought a driving street rod project years ago, 100% Henry steel, new floor, fresh 2 stage paint, interior, mechanicals needed attention, seller...
Sorry but it was Fatman Fab and not CE recommending rear bars on their site: "Rear sway bars come standard on all car frames to help control...
Chassis Engineering website states a rear bar is better than a front to prevent body roll, and I've got a lot of that. Have a Maverick 8" housing...
I have the door hinge mirros on a coupe and one hinge is sagging, my searches only turn up complete new hinges. Can I buy hinge pins or does...
I've looked at the aftermarket joints and its going to take a lot of re-inventing to graft them on. I'm told GM made replacment u-joints for the...
Got what looks to be late 70's Caddy steering column mated to MII rack/pinion which came with u joints below the steering column. One of the U...
Engine isn't jumping around at idle, looks pretty smooth. Definite low pitched vibration which goes away above idle. I've disconnected the belts,...
I'm wondering if vibration at idle with some resonance is caused by the thin rubber donuts on the aftermarket Mustang II mounts? It smooths out...
Separate names with a comma.