The Jalopy Journal
Hello Banger collective! I have been absent for quite a while. Thought I would let you know I am still around. Not much going on with me lately. I...
Checking in from Wyoming!
Checking in for the month. Yes @Jet96 I know all about the wind. HAHA. It has been unseasonably warm the last few days. I even drove the coupe...
Checking in a little late this month. Not much going on in Cheyenne. I did get my coupe out and drove it around 50 miles on saturday. It was 65...
Checking in from Cheyoming! Nothing really going on here.
I looked and I think you are correct. Thank you. These instructions I found online are confusing. The angle of the inlet and outlet got me...
Yes. My car has run with it set up for 5 years.
[ATTACH] Here is a pic of the pump and filter from when I was putting my car together.
I think I have the 67 size unit. I am running a Carter pump. I don't remember the number. It is a 12 volt one with the lowest volume. the pump was...
I have been using the Malapassi filter king unit for 5 years and have had good luck. I have the fuel pressure dialed down to about 2 PSI perhaps a...
Checking in from Cheyoming!
I am a little late to the party this month. Only a month to the Hot Rod Hill Climb in Colorado. I am getting excited for it!
Checking in from Cheyoming.
I am a little late to the party this month. Checking in from Cheyoming.
Good news! I can’t wait for September. [IMG] Sent from my iPhone using H.A.M.B.
Checking in fromCheyoming!
Miller High speed sells both adapter for AA bell to T-5 and T-5 4WD to torque tube. http://millerhi-speedheads.com/ I used a stock A bell with...
Checking in for the month! Not much going on in Cheyoming. I did have the coupe out the other day for a quick spin. It is amazing how a little...
Found this thread again after I talked to you on Facebook book. I was already subscribed. Here is a picture for a little inspiration. [ATTACH]...
Interesting that my cast head had no stamping on it. Hard to say what the deal is with them. its my understanding that the cast iron head were...
Here is my head. I forgot I posted this above.
Looks like the one I have with those small chambers. I had a friend CC the chambers and they came out to be about 8:1. I have yet to run it. Mine...
Ts are hard to drive between the pedals being super close, my size 13 shoe and being tall and big around I can barely fit into some T's and and...
I get confused sometimes when I drive several different cars in a day. Between the T-5 in the coupe, a standard 3 speed in the roadster and '30...
Checking in for the month from Cheyoming!
I found this thread about a week ago. Took me a bit to read through it all. Thank you for all the great details on your fixes. There isn't too...
[ATTACH][ATTACH][ATTACH] I built mine from 2x4 3/16 box. I used an aftermarket 32 front cross member and a stock A rear cross member. I also...
I like the build! I do have a question. Are you running a panhard bar on the front? with cross steer one should be used to eliminate bump steer.
I understand. Cling's builds a nice master cylinder set up like that too. I believe most of the model A parts vendors carry that one or they are...
[ATTACH] I built one that is similar to the one pictured out of angle iron and plate. I bought a master cylinder from Napa that fits a 1966...
Separate names with a comma.