The Jalopy Journal
With NY you must have a picture or tracing of the "vin". They issue a NON transferable registration and mail the correct reg after the vin has...
Correct rivets ???? All of the Willys I have ( VJ, 3 Trucks, 3 Wagons) use flat head screws
From the Spec sheet for PPG DPLF under preparation · Chemical treatment or the use of a conversion coating will enhance the adhesion and...
Pilot bearing
they still don't
Are the rear shoes adjusted?
Thank You
What is the best meathod to clean an area that has just been leaded to get it ready for paint?
It tracks the about the same at 6 as it does 4.5. Don't get me wrong it does go straight just fine. It is just quicker,and more sensitive that I...
I have been driving My 53 Willys Wagon (84 Ramcharger Chassis) and 55 Willys Truck both of which are slower and sloppy. It might just be that I...
It is power and the pressure and flow have been addressed, It is driveable but just not what I am used to ,At pressent its at 4.5 deg caster -0.5...
Its on a 48Willys VJ2 and I am trying to make it a little less reactive ,its at 4 now
How much caster should there be? How much is too much and what will happen with too much?
For sale "as is"
My ET Unilugs are 4.5 ,4.75, and 5 slots the washers work for 4.5 or 5(end hole) only or 4.75(center hole} only, but they are factory made this way
George Pierce John North Willys, Charles Knight
Around here Nat Gas legally is run in ,Butyl and/or Black Iron, LP is run with Butyl, and /or Flared Copper, most are done with copper but butyl...
I have an 84 727 with a lockup converter
Our local Napa has a guy that you walk in and tell him what you want he just goes back and picks it off the shelve. Then you need to wait a half...
1 lack of advertising, did not hear about it untill the week before 2 time of year, other shows and weather 3 for those of us that can only make...
Look up at the top of the tread and click on "Thread Tools"
Yes the switch can go bad for one light. The turn switch does separate each corner LF, RF , LR, RR
^^^^^^^ you'll need to be about 4 foot 2 to fit in there This is one I saw at Syracuse last year
"today i put a house fan in front of the radiator. it will idle at 185 all day with the old house fan and the mech fan....... i think i need to...
I would realy like to buy from my local jobber but my last paint from him would have been $ 350 more . I just can not give that much away because...
After being told that you can drive to work or errands every now and then ,Why do they require that you sign the Acknowledgement that states You...
The reason for third brake lights and their high mounting point is to draw the following drivers attention away from the blinking turn signal.
If its in a Corvette it is a Corvette Motor, If its out its a Chevy small block
I have a 51-55 Truck 327/SM465, and a 53 Wagon 360/727, of the two trucks that I built the one , the 51 had been converted to a 283 some time in...
TCI recomends 3 to 5 * of positive caster for a power rack with a GM pump
Separate names with a comma.