The Jalopy Journal
31 spline Detroit locker for the 10" quick change rear in good shape has minor scratches on side of housing has surface rust from sitting a long...
OEM Olds J2 tripower intake for 371 engine, supposedly these can be adapted to earlier 303's and 324's and later 394's, has 2 broken off carb...
I have 3 old underdash hang on A/C's,1st is a Frostemp 400 I think it is the oldest has a metal evaporator housing but the paint is coming off the...
Chevy 409 truck 4V intake,this is still the small port intake like the 348 but is a higher rise intake than the 250hp 348 intake and has larger...
250hp 348 4V intake in good shape no cracks just needs cleanup.Was blasted long ago including removing bottom shield but has rusted a little...
Made by Fenton, shifter only no linkage or mounting bracket,but I do have a bucket of that stuff so if you know the ID number stamped in them I...
Old Fenton shifter, no linkage or mounting bracket,do have a bucket of that stuff though so if you know the ID numbers stamped on them I may have...
Nicson boat rear motor mount for Flathead Ford V8.This bolts on where the transmission would have so if your block uses the half bell that bolts...
I have what I believe to be an early Detroit locker for a quick change rearend the ring gear flange is much closer to center than most other diffs...
I have a lot of Chevrolet pulleys both standard and deep groove small and big block,short and long water pump,some other GM apps too(Olds and...
Separate names with a comma.