The Jalopy Journal
[ATTACH] [ATTACH] These are pics of a So-Cal built 9" housing. The weld has no penetration. The housing is two years old and the car has been on...
My t-bird has always marked it's territory, and this incontinence was easy to live with given her 56 years of service, but coming home last week...
To make a long story short, Dick's Hot Rod Carbs is building the tri-power for my '32. He just went through a move to another state and does not...
I was trying to get the hood fit today and ran into a problem with the grill shell. It seems as though it's off center by about 1/2". Has anyone...
I PM'd a Chris Blattie here after doing a search and seeing that he came highly recommended. He answered back, I sent an email, followed up with...
Is this going to be enough room? If not, the only things I can think of are finding a smaller joint or sliding the column back further. I have...
I am about to order the try power for my 32 project. I went through all the good, bad ugly posts here about who and who not to buy from and was...
I've decided to put a manual trans in my '32 ford or project. I am ready to order it and had a couple of questions before I do. The car is going...
I have decided to scrap the auto trans in my '32 fordor project and go with a 5 spd. I had the floorboards mocked up with the 283/700r4 and...
I have a couple of questions regarding the toe kick front floor area. 1. How was the wood toe/floor sealed against the body from the factory....
Has anyone using a Vintique grill shell ever run across this problem? The first two pics show me holding the bezel in place and how it lines up...
I am in the process of removing the doors on my fordor body and am having trouble with both front doors. Both rears came off without too much...
When I was messing around with my deuce fordor I noticed that the front doors can be locked from the outside with a key or from the inside with...
...and how much should I be asking for it? I am pretty positive it is not original to the car ('32 fordor). If it's worth something I'll get...
I started cleaning and measuring after getting the internals back for my 283. The machine shop screwed up and used 2 rods that were small...
I am building a 283 for my Deuce and have a question about the crank. I had my machine shop get the block and crank from his core yard and do all...
It seems like it has been forever trying to get this car going (in reality, just a few months time). The short block is at the machinist, most of...
I am building an A fordor on deuce rails (if I ever find a body) through JimA's shop. The car will be driven almost daily and mainly around town....
I thought this might interest some of you. I was editing home movies for a family member and made some stills from this footage. The quality is...
I am still gathering info and sources for building a '32 tudor. I posted a while back if anyone knew of manufactures of these bodies and followed...
I hope this is the correct place for this question? If not, let me know and I will re-post. I have a t-bird with a 525 Road Demon. I had a...
I am getting ready to buy parts and start building a tudor and was hoping someone will be there tonight to talk to about building, which vendors...
Does anyone know of a source? I have been searching but all I seem to come up with are Gibbon (no response and questionable quality) and Deuce...
Separate names with a comma.