The Jalopy Journal
I've ran one a long time like that and it hasn't caused any problems.
If ya have enough kids you can put a mattress behind the seat and put a couple back there for long trips. I've ridden a lotta miles behind the...
usually set the toe to 1/8", I think this is to allow for the spread that occurs when the slack comes out of all the joints tying the 2 wheels...
I'd say it's a fuel delivery problem. has the car been setting a long time? You might wanna try blowing back thru the gas line to the tank....
Make sure , let me say that again. Make sure that all of the butterflies are closed when it's supposed to be at idle. with the engine not...
Has it stuck in the last month it's been sitting around or has it been locked up for a long time. After checking the other things mentioned take...
I've been running one in a 385 for 12 years, no problems
4 1/8" stroker, 3 3/8" pistons, MCF cam 21a rods Offy heads, Headers, Mallory electronic Distributor.MCF oil pump, adjustables, Uncle Max's 97's...
I ran 2 x 2 for a long time ran great and fairly economical. Put 3 97's on with straight linkage. It was like adding half another motor to it....
Dammit man, I have trouble stompin a beer can flat! That is awsome work.
sounds like screwdriver to me
You'll have a lot easier time setting it up with straight linkage. Just be sure that you have all the butterflies closed and all of the throttle...
I put a blower motor out of a cutlass in my heater. Had to change the fan best I remember, wasn't too much trouble.
NRchopshop I ran mine under but that isn't the way it should go. I'm pretty certain that it should be ran above the clutch crossover peice . I...
couldn't rotate the diff. a little to line it up?
does it roar and grind and vibrate and leak dope all over? if so it probably is
look for an edlbrock su-349
Matter of fact I bought the dropped spindles, dropped arms trick tie rods, and I never could get the 50 ford to drive worth a dam. I had a bunch...
I bought em didn't help a damned thing save your money. rebuild the stock stuff.
There's a big nut just under the front of the generator, you have to loosen that nut and pull up on the generator to tighten the front belt. I'd...
I use the mallory magnetic breakerless in my 8ba. 38 x 3/8 got 3 97's big ass motorcyity cam releived ported and polished . never one seconds...
Here's what I do, it might not be right but it'll help get you started. When you start your arc and start getting heat into the aluminum put...
If I'm not mistaken you need to gap your plugs about .018 don't ya?
What a pile of shit, no red wheels , no iron crosses, no flat black paint, no junky assed home made headers hanging out of it, no mexican...
I saw a 50 ford coupe in pigeon forge in september that belonged to a california fellow named Bill Orick, it had a427 cammer in it and it was an...
How bout these Ona House Ora House Hanlan Cox
I'd bet on the clutch plate being rusted to the flywheel. if it's where you can drive it, get it out and jerk it around a lilttle, kinda easy...
No probblem 40 standard. You got yourself a damned rare care there. Enjoy it. :)
If I could post a picture automotive stud I could show you,, there are NO PUMPS under the hood. It is run by VACUUM. There may be hydralic oil...
They have a cylinder on each side, they are powered by vacuum. Does it still have the steel vacuum lines on the floorboard. they're about 1/2"...
Separate names with a comma.