The Jalopy Journal
Yes!
Did you consider trimming the edge of the combustion chamber. Wouldn't take much and you could use the gasket to scribe the line. Just a...
I did this once on a Gremlin I owned. OE used one 30 amp fuse to protect(?) the A/C compressor and the high speed blower fan at the same time....
"And my wife will ride in it!" "I'm still on my first girlfriend (well, wife for the past 40 years)." Looks like your priorities are correct!...
Sometimes the wanting is better than the having! .bjb
Looks like the body is too far back on the frame. Maybe it's an optical illusion. Looks nice though. Not too sure about those fender mount...
Maybe he's not low enough yet. If you snip off the tails, you can't easily pull them any tighter. You have to wait until the test drive.
I don't think it was built to win the "Most HAMB Friendly Roadster" trophy. Perhaps if there was such a trophy... .bjb
That's nice, but what time is it?
Second thought: Why were they called DASHboard? Why dash? It's a throwback to the horse and buggy days. The board at the front was to keep mud...
When I built my coupe I considered a chop, but it was already channeled about 5" so I was concerned about being too low on headroom. So I went to...
50 GMC would have been 6 volt, which doesn't require a ballast resistor. 12 volt requires one. .bjb
Is there any way to make "full image" the only option?
WOW!
I put a fork lift type connector on the firewall to plug into my jumper cables. It's the gray plug mounted down low on the passenger side in the...
My battery is under the seat. I just mounted the seat on a big hinge and pull one pin to tip the seat 0ver. .bjb
I think we all need a hat like this. Where did you get it? .bjb
Left hand drill bit??? And some penetrating oil. .bjb
Same as every year. I want to lose 2 pounds. Hasn't happened yet. Aim low. .bjb
Or a piece of chain and the spare tire! .bjb
What are those hairdos going to look like after riding in that open car? .bjb
The way it should still be. My opinion. .bjb
Definitely not a Ford nine inch. Maybe a much older Ford rear. Left hand thread???????? .bjb
Bumping????
Thank you. .bjb
I went to a local fabric store and bought a bunch of denim. Not everyone's cup of tea, but I like it. .bjb[ATTACH] [ATTACH] [ATTACH]
That's a good idea. You could run tubing like you would to a mechanical gauge. Then hook the sender to it and, as you said, ground it. Pretty...
Looks like you have earned a PhD. Piled higher and deeper. Just like a lot of us. .bjb
Thanks for all the great information. Does anyone know if any original 200-4R equipped cars came with a floor shift. I'd rather have an OE GM...
It's a 34 Chevy. Right now it has an Ansen scattershield so the bellhousing area should be ok. I think my floor is high enough to clear,...
Separate names with a comma.