The Jalopy Journal
Sold, thank You
1946 Mercury 59A flathead. Rebuilt several years ago. I had a machine shop disassemble and put back together. Valves done, new adjustable lifters,...
'46 Mercury flathead removed from restored car that was destroyed when roof collapsed. Machine shop tore it down, tanked it, checked it and put...
'55 Chevy 3100
Need a clutch disc for a 235 with a T-5 hub. Who can custom make one?
1946 Mercury flathead. Removed from car that the garage roof had collapsed. Car was restored with rebuilt motor before the damage. Machine shop...
brand new GM 10 inch 14 spline. Came in a kit for a Chev 235 with. 3 speed. I'm using a T-5 so I had to use a different disc. $30.00 plus...
Zips has been making these for awhile.
Last refuge body, Bill Metz frame, GM 350, TH 350, Ford 9in. 12 k firm. Trade for original Model A. [email protected] Sold , Thank You
D&D Automobilia can recast the lens. They recast steering wheels also. Check them out on Goggle. They are located in Mt Airy, NC.
Rocky, how can this be a street rod?
Thanks, I see where it belongs
Flange on push rod is moveable. Where does it belong? Thanks
trying to use all the parts. Does #1 fit in #2 and sit in the block before the intake is installed?
Correct me if I'm wrong. Multi grade Brad Penn doesn't have zinc, only the straight grade green does.
88298 is 1977 Johnstown, Pa. Flood
I believe the cable goes behind the kick panel. I can take mine off without disturbing the vent cable.
Talk with Tom Langdon at stovebolt engine. He sells a kit with Holley Webers that is very well known.
Since I started this thread, I'll give a update. Speedway won't stand behind lifters they sold, CGM Motorsports sells Johnson Hy-lift. In a...
Can' believe they didn't take care of this.
Does anybody have any opinion on Bob Drakes $140 lifters?
In the middle of a 59a flathead rebuild, I must decide if I want adjustable lifters. Who sells good lifters. From what I've read off shore lifters...
Model T and Divco, 6 volt T-3 headlights, Fram C4P filters........... C4i 25-27 close to 37 kid and Brookville
I share spaces with a guy that has a lot of T parts. I told him to bring rear springs for sure. C4I 25-27. Stones throw from the THE 37 kid
Let me put the new line to rest. I was able to buy enough of the line to last me the rest of my life. It's copper coated steel and polishes up...
Thanks for the suggestions.
I have a lot of pre bent copper coated 5/16 steel line. I need to straighten it so I can re bend it for my project. Somewhere I saw a set of...
Its about time.
Divco sold many engine retro fit kits. As far as the club, I think the $30 gets you a newsletter. I can give you leads on parts, email me....
Separate names with a comma.