The Jalopy Journal
thanks for all of your input, great article by (themoose) valuable lesson really tells us the importance of the vacuum system
the motor is a 427/425 corvette, it is ported vacuum in the correct vac.port. 10" at idle is very smooth. still no vacuum from that port when i...
my 4 barrel holly carb using the ported vacuum for my vacuum advance has no reading on my vacuum gauge as i run the RPM up. what gives? is it...
what does it take to make a 355 cu. in. chevy small block?
my 34 is in laquer primer, decided to knock down and spray with an epoxy primer. just how far down should i take the old primer down to get good...
will call joe hunt and ask what is in distributor. thanks
my 53 flat motor with a joe hunt distributor mechanical advance seems to like 10 degrees initial timing. is this normal with a isky 400 junior...
thanks for your response, better safe than sorry
just got my distributor back from joe hunt distributor. sent out with a 2 wire hookup got back with 3 wires out of dist. where does the second red...
:confused:my 54 chevy hood is way awkward when it comes time to close have to push the rear side at the cowl on both sides down before attempting...
thanks for your input, will call them monday morning , i know where it is located is not helping, lot of engine heat i presume is not good for it....
yes it is a mag look alike. any idea why its breaking up over 3000 rpm? i am using the ballast resistor, when cold runs great, have noticed the...
having an issue with my 53 merc breaking up and backfiring over 3000 rpms... doesnt seem to be a fuel issue. running a joe hunt distributor. does...
billet proof garlits is on the 17 th of march. be there or be square.
march hemmings has a page write up on the 50 pontiac. only built 40 thousand 6 cyl. pontiacs almost triple the strait 8s
thanks for all the input, seems like the GM pellets has been used by a lot of you guys out there....give it a shot tommorrow and see what happens....
my 53 merc with e-heads decided to start seeping anti-freeze out of the head studs. the studs were sealed in the block...and torqued to 60# short...
choprod, you hit it on the money, shimming doors is all about fitting the cab to the frame.
hey, thanks for all the input, new address is florida, michigan winters suck. i run strait 50# valvoline racing oil, was thinking of streching oil...
my 53 merc flatmotor has great oil pressure (around 55 lbs when driving) running strait 50 weight oil. problems come in at idle, dropping to...
Separate names with a comma.