The Jalopy Journal
Does anyone know who the original cam grinder(s) are for these cams and what the basic application/usage might be for each? Hot Street or maybe...
With Bill Jenks retiring about four years ago and then about six months after he retired, passing away, what happened with the two Storm Vulcan...
Does anyone know what the specs on this grind is? Thanks, Roger
Does anyone know if they are still in business, a temporary shut down for something, or are they on vacation this week? I have tried calling them...
What were Champion J-3 plugs used for in Flatheads? Racing only? Is there a difference between the newer Champion H10C vs. the older Champion...
Early 221/239 split valve guides are 5/16" I.D. Are V8-60 split guides also 5/16" I.D.? Pretty sure I know the answer to be 5/16" I.D. also, but...
I am wondering what the opinions are on how a T5 drives that has the 4 cyl 4.03 gearset. It seems that this is a pretty wide ratio transmission...
Does anyone have a picture of an original Number "1" that was used on the frame or motor? That is the early style "1" not the later one that...
Has anyone had any recent experience registering and titling an in-state antique car with a previously issued original NC State issued title? It...
Is there a difference between a 1940 Ford regular pickup truck axle and a 1940 Ford car axle as far as the king pins go? Is there a difference in...
What is the outside diameter of Flathead Ford V-8 Valve Guides?
I have a DT-400 Sun Distributor Tester and I am looking into what it would take to test electronic distributors. Does anyone know the Sun Pulse...
1. They are based on the 1932-1948 Ford Banjo rear end, right? 2. Besides the ones that you built yourself out of several banjo center section...
Has anyone ever put a 6-71 blower on a SBC 265? If so what sort of underdrive ratio did you use to get somewhere in the range of 6-8 psi of boost?
Does anyone know what the clearance is supposed to be on these? They are FE 406 pistons, 0.030" over (4.19" bore) It seems that I remember...
Does anybody know what they are? Roger
What size clutch would be recommended for use with a blown flathead motor? 9", 10", or 11"? Estimating my build to be about 220 HP, so it is a...
I found a set of 81T Aluminum heads. So far I can only find info the cast iron versions with about 83-85cc chambers on trucks from 1938-1942....
Anyone know what stroke crank a Jahn's 192X piston works with?
I need a bell housing that will take an 11" clutch, but I am not concerned with match numbers so it could be from a truck or car. So, does...
I have a set of 1935 Ford 16" x 4" wire spoke wheels to use on my rpu. What are the typical size tires to use on the front and on the back?...
What years were the cam cores made of billet steel? I know 1932 and I believe 1933, but what year did Ford start using cast iron billets, 1934,...
Does anyone know any addtional cam specs such Duration at 0.050" lift or its usage like 3/4, full race, etc. on this cam? Does anyone know who...
Would this be a date code on this late 1930's factory Ford 2 BBL Flathead Aluminum Intake? It is cast on the underside of the intake and looks...
With all the Windfield cam copies out there, does anyone have an original Winfield cam so you can measure the height of the letters stamped on it?...
Separate names with a comma.