The Jalopy Journal
I set my toe by just using a tape on the front and backs of the tires -- same point on front and back -- 1/8" in. Came out fine and took out a...
I'm using a Chassis Engineering axle. It's forged. As 117harv said, this subject has been thrashed over and over several times.....
I agree, assuming the OPs wiring is correct, and the relays operate properly. If that is true, then: the OP has a bad motor (shorted) or his fuse...
The diagram is correct, and as 31 Vicky said, 87a should never be hot (it is grounded). Looks like a simple case of miswiring somewhere. FWIW...
I believe Johnny Law Motors is part of the Hoffman Group. http://www.jalopyjournal.com/forum/threads/autoloc-hoffman-group-etc.618388/ I don't...
[ATTACH] Seven inch section out of mine.... But for fiberglas flthd31 did it right. Seam will eventually show if its sectioned.
Yes, the wood pieces sit on the frame and go up into the subframe, and the body bolts go through them. Coat them with a good wood preservative...
Took 'er out Friday. Had no place to go but I went anyway
The white bucket was Fred Steele's, there's a thread on it ....
I'm not familiar with that switch but you really want one that closes both in park and in neutral -- my rod quit as I was going through an...
Tomorrow's date is 12-14-14 ... the last time this occurred was 100 years ago..... Oh never mind.
Looks like a few of those photos were taken at DVAP in N Phoenix... I was there some years ago.... http://lakeboon.com/dvap.htm
More unburned fuel getting into the exhaust on decel -- i.e. now running richer. Something has changed / is changing. Check your carb, is your...
For a permanent propane heater in your garage, install a direct vent wall furnace. Much safer, and you can leave it on all the time with the...
You cannot. If you send PP for goods or merchandise you are protected. If you send it "to friends or family" you have no recourse. Actually when...
Helix is part of the Hoffman Group. Search it.
2 wheel drive S-10 rear axle is the perfect width, only issue would be the Chev bolt pattern.
What I was going to say. Good decision.
I finally know what "the silence was deafening" means (1 minute 19 seconds).
First (and easiest) thing to check.
28 - 29 tank as viewed from front of car... http://i.ebayimg.com/00/s/NzY4WDEwMjQ=/z/y58AAOSwd4tUFzAp/$_35.JPG
Yes, if the purpose of the switch is anti-theft, just put the fuse across the switch terminals. It does not matter that the switch is in the...
I agree with this -- if the cap cannot pull water back into the system from the overflow tank and the engine cools, it will create a vacuum in the...
Just ask the county for a certificate of appointment. They should give you one (an original, sealed one) for a few bucks.
Murdered out cars are cool.
I had the same problem when I bought a Jag XK120 back in the '60s (they were cheap then)... I'm 6'2" and had to replace the stock seat bottom with...
from OCW: Auctioneers intend to run two to three rings during the ambitious one-day-only sale, with loading continuing clear to Sept. 28. Expect...
I do the same, with the Permatex Copper. For plain nuts and bolts I use the Speedway.
... and don't ever sell the original frame.
Yup. And the other thing I learned with MIG is don't hold the gun vertical, tilt it to 30 degrees from horizontal -- you won't blow through.
Separate names with a comma.