The Jalopy Journal
That's a good suggestion.Didn't think of that.Thanks
Thanks for all the replys.I think it might be to short.
All right,with the frame supported and the weight off the rear.The drive shaft goes into the tail of the trans.The measurement is now 1 1/4".Not...
I have the jack under the rear.I'll try it hanging free and see whats left in the trans.
I have a 56 f 100 with a C4 trans and 8 inch rear.Right now the yoke is 2 1/8th inches inside of the tail shaft of the trans.That's about half of...
Merry Christmas Everyone!
Looks great.
Thanks for the replies.
The bed sides of my pickup bed were painted with 2 K primer 8 months ago.If I sand them with 180 sandpaper can I paint them with Blk. urethane or...
Sorry for waisting your time.There are only two drain plugs.One on the back of the driver side and one on the front of the passenger side.These...
Thats beginning to look like the solution.Thanks for all your help but I sure would like to know what the answer is.This is my first Ford engine...
I tried 1/4" npt and they were to big.1/8" to small.Is it possible that they are Metric?
Thye're allen head plugs.
was told it came out of a mid 70's ford .there's two plugs on both sides of the block.They're below the freeze plugs and above the the oil pan.
I have a 351 w block dated D4AE which the previous owner removed one of the 4 coolent drain plugs on the side of the block and tossed it away.I'm...
I put 50 merc tail lights in the fenders of my 56 f 100.What I did was make a sheet metal pattern of the back of the housing and played with that...
I like your direction with your truck.In fact I'm doing a 56 f100.I frenched in 50 merc.taillights.Quad headlights with a stainless bar...
Nice condition to start at.Way better than mine was.Have fun with it.Great cars.
Is it possible to put a cable into the back and turn it with a drill and see if it makes any sense by what it regesters?
laminated windshield tempered glass every where else.56 F100.
When I bought my ply.[35 yrs.ago] it came with those jump seats.They weren't mounted in the car.I used a normal back seat out of a newer car.I...
I bought and used this tool to replace the door latch on my 41 ply.Removed every screw except the one I striped the head on 30 years ago.Worth the...
I've been driving my ply.for 26 years.Still far from being done.In fact this week I hope to replace the org.door latch in the passenger door with...
Rock and roll,Blues and country.
You replaced the tank,fuel pump and carb.Did you replace the fuel line between the tank and the carb?What is the dia. of the fuel line?Is it all...
When I stripped the paint off of my 56 f-100 I used a cheap Harbor fraight 4 1/2 angle grinder and Norton Rapid strip blue wheels.Didn't have much...
I'd go with the Ply.But then I'm a little biased.
Nice truck.Have fun with it.
Been a member of the"Wheels Of Time" of the Lehigh Valley,Pa. since the early 80's.
Allright, just read my question and the needle and seat should keep the fuel in the bowl.Still wonder about the fuel pressure in the line.Thanks
Separate names with a comma.