The Jalopy Journal
[ATTACH] Measurements on my hood latches are: centerline of front latch 3 1/2" from front of hood side, centerline of rear latch 7" from rear of...
Maybe this is it? Fragola 650310...
External terminals 05nopro440 mentioned using. $27 Amazon [IMG]
The purple starter wire does not run thru a relay, but it should run thru a neutral safety switch. Either the neutral safety switch needs...
[ATTACH] Twin Edelbrocks
I used to use the Lucas ZDDP additive, but it was $15 a pint bottle, now I switched to Castrol GTX classic oil, its super cheap too. [ATTACH]
I'm running 185/70/14 on the front of my 32, no rubbing issues. 14-inch rims do limit the size of disc brake caliper that can be used, due to...
I ran two 650s on a C-26 on a mild 350 with a 700R4 auto trans. The C-26 is good for mild mannered street driving. I did experience a slight bog...
The last picture on post #26 shows the original distributor location rotated about 90 degrees further clockwise from where you presently have it...
Thats where the detent cable connects to the transmission and runs to the accelerator linkage at the carburetor. This cable operates the detent...
A friend of mine has been in the process of restoring a 1936 Master Sedan for the past 8 years or so and the restoration is currently stalled, due...
I subscribe to the old Groucho Marx quote "I refuse to join any club that would have me as a member." When asked to join any local car clubs,...
I'm running AC on my 32, so it was convenient to just use an adjustment bar from the top of the alternator over to the top of the AC compressor....
"Shit for brains" refers to the new dumb guy whose name I don't know (my fathers favorite quote) "With that being said"........my bosses...
You are using the wrong Bosch relay. According to the part number you listed, you have a relay with dual 87 terminals and no 87a terminal. Thats...
For any critical electrical circuit that requires a relay, I would recommend using a top of the line quality relay, such as Bosch, Hella relays...
https://www.jalopyjournal.com/forum/threads/zips-water-pump.751509/ Review this previous thread concerning this same topic. Post #30 by Johnny...
My setup is similar to yours, I have a 180 thermostat with four 1/8 inch holes drilled in the thermostat flange, as others have suggested, , a...
The Zips pump instructions indicate that this system needs a bypass setup to operate correctly. The instructions state that if no heater is...
In my experience, the POR-15 is going to be superior in rust prevention to powder coating. My trailer steel wheels were exhibiting signs of rust...
If its an earlier case as Squirrel has alluded, then it may have a 28-spline carrier vs. the stronger 31-spline unit. If you already have axles...
[ATTACH] Here's my open trailer. It's a H & H trailer that was new in 1986, I bought it six years ago from my old boss for $50. I've refurbished...
Is this horn relay for a 6 volt system? If so, if you can't find an OEM relay, I would just substitute a BWD R102 relay, they can be purchased...
They look to be obsolete Try http://www.oldmoparts.com/
More specifically, a P15 Horn Relay
I agree with BJR, either way you go, you will have to repair or replace the wiring that got damaged, so why not stay with the original gauges?...
You need to have a metal channel that extends down into the door to hold the window moulding in place as the window is raised or lowered,...
If the ring & pinion are rusty, then I would imagine that the internal limited slip components such as, side gears and pinions, clutch plate,...
Doug is a good guy. I was looking for a 1936 Chevy rear door hinge last year for a friend, Doug had one on a car in the yard, price was $100 plus...
I've used the spark plug air adapter on my SBC several times, it works great. You need to use about 100 psi to keep the valves in place while you...
Separate names with a comma.
The Jalopy Journal
