The Jalopy Journal
I was wanting to change the gears out in the rear end on my 53 chevy. It has closed drive and it's a 3-speed. I was wanting to put some highway...
Hey guys, I need a solenoid for my 53 chevy. It's on 12 volt system now. Do any of you know where I can get one, and do you happen to know the...
Can I get a 4bbl intake for my 53 235 chevy engine?
are the gambino kustoms 49-54 taildragger kits to be used with stock rear-end in a 53 chevy car?
I'm sure that this might be a stupid question, but I've been looking at the dash in my 53 chevy and I was wondering if there was a way to take it...
I have been thinking about rebuilding the engine that is in my four-door 53 bel-air, but i'm not sure if it's a 216 or a 235. It's the original...
I'm getting ready to do some more work to my 53 chevy and I was wondering what rear ends are you guys were using? I'm taking about the original...
hey guys, I've been thinking about getting an air ride setup to put on my 53 chevy. What would be a good kit to look into and how much of a...
I recently got a set of Firestone 670 WWWs. THe first time that I drove my car with them on, I slung a hubcap and it caught the valve stem cover...
Hey fellas, I recently bought a 53 chevy four-door from a guy on here and I've been trying to figure out what to do to it. Can some of you guys...
Ok, I know that I am totally opening myself up to the cool kids who say that four-doors can't be customs or hot rods, but that's ok with me....
hey, Do any of you guys know where I can buy some floor pans for a four-door 54' Chevy? I was told that I might be able to find some that would...
I'm gonna try to make the drive up there. I wont have a car ready by then, but maybe I can pick up some stuff at the swap meet. So who's going?
Yesterday I posted something on here about how I was having trouble with the spring being on the front of my front axle and I was wondering what...
hey folks, I've had a guy doing some frame work for me, because it's my first build and I can't trust myself to do safe frame work, and we are...
Hey folks, I've been building a 46 chevy truck into what everyone else has started calling a "Rat Truck." This is my first build, so it doesn't...
Hey folks, I'm new to this message board stuff, so I hope i'm doing this right. I guess that a good introduction would be that my name is...
Separate names with a comma.