The Jalopy Journal
For sale a new intake tri power that uses ford or holley carbs Was powered coated I had it Sat on a motor only Intake cost 577.00 and powered...
For sale a chevy magneto has spark needs a cap and wires Best is to email at [email protected] or call or text me at 218 206 1312
Have a magneto for sbc or bbc has spark but needs a new cap and wires Will ship More pictures at Instagram terrywh566 Best is to text me or...
For sale a 3-2 intake for sbc New intake powered coated with 3 new ford carburetor 2bbl 700.00 cash More pictures on Instagram terrywh566 or...
Can someone tell me what motor mounts and oil pan and exhaust manifold to use a gm ls into a 1956 ford car Are they the same as a mustang ones...
Thanks he has them
Yea you need different shaft to do it Must be someone doing it
I have a tri power intake trying to find base for the end carbs All I see is small base for sale Thanks
Yea the dyno are nice to have they start at 400.00 and up to put it on one the place buy me is a big a$$ he will just run it couple time a and...
400 crankshaft are harder to fine I could not find a good one so I bought a scat
383 is a 350 block with a 400 crank or aftermarket crankshaft Yes the 400 has less thinner walls then the 350
Thanks when I did it with one chart it was 327 hp
Look above your post
Chevy 406 9.8 compression 251 .050 exhaust 243. .050 intake 515 lift 304x296 advs Roller camshaft .039 head gasket .020 deck...
I will get all this morning for you
Trying to find the horsepower of a engine
Need some help trying to figure out horsepower calculator I'm lost trying to figure out how to use it
69490 headers should work
Yes I was told but my headers I have are to small for my motor Have a 406 with a .513 roller camshaft and 9.5 compression The header I have...
Not on my Chassis it in a s10 Chassis what the headers are designed they hit the tubes
Ok that what I thought they were stock locations The trouble I'm having can't find header to fit in my Chassis with angle plug heads
Are gm bowltie heads have raised exhaust ports trying to make shure trying to find header that will work The problem with the header they...
Cut up for parts no longer a car
It got scraped out all cut up for parts or sale again from a dead bet on here didn't come through 1956 chevy Delray 2 door sedan or club...
Some things will cost to much to ship all the parts are new besides the engine and transmission and rearend
For sale 1955 1956 1957 chevy parts New parts Floor pans under the seat Floor braces have 8 of them Rockers outer 1956 and 1957 Inter rockers fit...
Just a roller no extra parts for 2800.00 or can sell you with extra parts
I will sell just a roller only or with the new parts
Sold For sale a 1956 chevy Delray 2 door project roller comes with the stock front fenders thats needs work Best to call or text 218...
Separate names with a comma.