The Jalopy Journal
I have a set of 40 ford front hubs/drums. Can the hubs be separated from the drums and then the original drums be used as slip on style drums much...
That’s what I’m about to embark on.
Thank you for the advice. Looking from the inside of the body it looks like a shitty job. A lot of cutting and drilling of bolts/screws.
thank you very much for the tip. I see a plate with some Phillips screws sandwiching the two pieces I’ll start disassembly
On my 30 Tudor the rear portion where the spare tire mounted is rusted. I have the replacement panel but I’m looking for some guidance please on...
I think you’re right on the 145 tooth. So if this one is 145 tooth it will be neutral balanced and be what I need? Thank you.
I have a 52 331 caddy motor I’m converting to stick shift. I found an early Weber olds cad aluminum flywheel. I have read some motors took a...
Oh interesting, that’s good to know. I’m super new to these and just assumed the shop stamped them. Thank you!
Mine came state side not from Canada. Is also brass not aluminum.
I did message one fellow but no response yet. Keeping my fingers crossed I can find someone. Cheers!
Thanks for the suggestion! If I can’t find a way to do it like it used to be done then this is a great alternative.
I recently bought a nos isky cam tag, I was wondering if anyone knows where I could send it to be stamped like isky used too? I have a 400jr in...
Oh man that’s terrible! Hoping for a speedy recovery. Thank you for sharing.
I know this is super old but did you ever figure out your issue? I’m going through a similar situation with my flatty and dual 97’s
I removed one of the carbs confirmed that power valve is good. Going to pull the other and check it. The old school speed shop guy who sold the...
Ran great initially for quite some time and yah now this issue has come up. I opened up the rear carb today and made sure everything was clean and...
I am running both.
Hey everyone I could use some wisdom here. I have an 8BA with an isky 400jr cam, thickstun pm7 intake and two fully rebuilt stromberg 97’s and the...
Looking to find what these gauges would have come in, id like to buy more. Thanks!
I’ve cut the perches off, building a mount off the f1 crossmember isn’t an issue. Just curious if anyone has done it or if there is oil pan...
Wondering if anyone using a model A frame and running a flathead was able to make 35/36 front wishbones work unsplit?
[IMG] Clutch kit recommendations I’m in the market for a 10” clutch kit for my 8BA with a 39 style trans. None of the local parts shops in my...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] I have a mallory dual points distributor for an 8BA flathead. I bought it and never used it ended up...
That would be fantastic thank you
Is anyone reproducing 1938 ford gauge faces? Mines pretty rusty. Or reproducing an overlay?[ATTACH]
I just measured the rod and it inserts about 1.5” Into the master just to seat. No engagement at that point yet.
Hi the brakes are not bled or plumbed yet. The master does have full travel to return but the shaft for the pushrod to sit in is deep inside the...
I figured there might be an issue with the master but I had nothing to compare it too. Man thank you so much for helping solve this!
Thanks for the reply, so the master is new from rockauto it’s a centric brand. It’s single pot like original. The pushrod goes deep inside the...
I posted a couple pictures. As you can see with no return spring the pedal is laid far forward. (I still need to heat and bend it past the block)...
Separate names with a comma.