The Jalopy Journal
SOLD
Y not a Y block?
BTT
Intake is still available. Open to offers.
Back to the top
Updated price: $1250
Still available. I can also meet within an hour or so of Raleigh, NC
BTTT
Bttt. New photos added. Intake is off and ready to ship.
BTTT. Intake has been removed from vehicle. I will post additional photos soon.
Up for sale is a Weiand FM 436 3x2 intake. Ford Y-Block 272, 292, 312. Includes 3 Holley 94 carbs which have been sandblasted and powdercoated....
Why would I think that? Why would I ask a question on a site that has a wealth of information? Why would I look to an older generation of people...
Hello all. I've been working on dialing a 3x2 carb setup in on my 1955 Ford Customline. It's a mild Y-block build. 304ci. Isky cam, gasket-matched...
So after some closer examination. The inner spring is supposed to sit at the same height as the outer spring, which it obviously does not. This is...
I have a thread on yblocksforever.com already. The dampner is brand new and the timing is correct. Sent from my SM-G973U using The H.A.M.B....
Sent a message to Isky. We'll see what they say and I'll report back. Sent from my SM-G973U using The H.A.M.B. mobile app
Update: I got 8, 1.43 ratio rockers resurfaced and installed them on one rocker shaft and then reassembled a shaft with 1.54 rockers to check for...
btt for this one. I'm moving again. Can anyone use this thing? $50?
Check the casting number on the side of the rocker arms as well.
I purchased my Red's headers for $350. I would check to make sure the welds are not broken anywhere, I've had to have mine repaired. I looked up...
Ok, so this is the plan for now. I have drained the fuel out of the tank, just in case the fuel is starting to go bad. I have new pushrods...
I'm going to check on that third rocker when I get home this evening. On closer inspection of the photo, I think it may be a casting ridge. We...
Updated to a more specific location. I have no issue providing beer, pizza, discounts at the dealership to anyone who could assist me. I just...
As I stated on an earlier post, finding people locally who are familiar with these engines has been a challenge. I honestly have no idea if there...
This is not an interference engine. Did not see any contact between piston and valves with a bore scope before engine was ever fired. I feel like...
All rockers move freely. They are on brand new shafts. Anti-seize was applied to help lubrication during initial start up. I have upgraded to a...
It very well could be. I have the assemblies down in the garage. I won't be reusing any of these rocker arms. Sent from my SM-G973U using The...
I'm positive oil is making it up to both rocker shafts. I primed the engine before the initial start up. It has run, but never for very long, and...
So finally got out to the garage to pull the valve covers and begin the diag process. Any idea as to how this could have happened? Poor casting?...
Only one vacuum port on this intake. I have a T fitting in it with one hose going to the brake booster and the other going to the valve in the...
Separate names with a comma.