The Jalopy Journal
[ATTACH]
13 Sep 1959 Caddo Mills Texas. [ATTACH]
My fuel pump started leaking and I need advise on what to do. I would like one with a sediment bulb. [ATTACH]
I put it in 1961. Still runs good.[ATTACH]
That's me on the left somewhere in the middle of Oklahoma on the way to the NHRA Nationals 1958.[ATTACH]
Bobby Wolcott and Bill Collins about 1960.[ATTACH]
Can I use a 1964 Grand Prix frame to replace the frame in a 1963 Catalina Convertible?
This is a stock 32 pickup front mount.[ATTACH]
Mickey Thompson at Caddo Mills Texas 13 Sep 1959. [ATTACH]
Caddo Mills, Texas Championships, 13 Sep 1959.[ATTACH]
Caddo Mills Texas Championships 1959.[ATTACH]
I have several pictures from 1959 Texas Championships. Are they too new?[ATTACH]
Those new bearings with seals on both sides are packed with grease and the seals are dust seals. 57 bearings have a oil seal on outside and o...
24 stud Ford flathead on this one.[ATTACH]
I would like to see a Quadrajet base gasket set on that manifold. No finer primary metering system than a Quadrajet. 283 CID Chevrolet ran good...
I spend a lot of time looking at pictures and reading on H.A.M.B. A couple of weeks ago I found this picture on Moriarity’s 3x3 Photo Thread. I...
See post #16 in the 3x3 Photo Thread. Jacksonville, Arkansas. 1962. 1931 Chrysler B/Gas. 1957 Pontiac V8.[ATTACH]
Here's mine.[ATTACH]
I get asked a lot if I converted it. 1965 GMC K10 V6 three speed when I got it. Only things still original on it are the frame (short 1 ton) and...
My shop truck. Originally four wheel drive. Got it in 1968. 400 SMC 400 THM.[ATTACH]
1965 Labor Day Weekend, Green Valley Drag Strip, Smithfield, Texas.[ATTACH]
Need small gap between distributor and intake. Pry or slide hammer it up until brake cleaner can get in. It's worked for me.
1958 NHRA Nationals Oklahoma City Car Show on Saturday night Labor Day weekend. My brother Jack Ott (1939-2017) took me with him. We had a great...
Do you have a copy of George's book. 100 pages? About George and his dragstrip. A lot of pictures. I'm not selling them just have a copy. I have...
Sorry for the confusion. I not really good at this. I been reading the Caddo Mills thread. I went there after the 59 AHRA Nationals at Great Bend...
B/Gas 57 Pontiac 347CID bored to 370CID[ATTACH] . Spaulding Flamethrower, #10 McKellar heads and cam kit with 1.65 rocker arms, Jahns pistons....
There was a car show Saturday night and I took a few photos. This car was one of my favorites. Carl Stone's 32 roadster was my favorite.[ATTACH]
The 31CM was a good choice for a hot rod. Larger and heavier than a Ford. We were kids and it was safer. Big heavy frame and plenty of room for a...
The summer of 1962 my two brothers and I raced our 31 Chrysler there. At that time George paid the top eliminator of the day. We won it several...
Yes, how much is determined by the number valve you use. The larger CID the engine will use a valve with more loss than a smaller CID engine. The...
Separate names with a comma.
The Jalopy Journal
