The Jalopy Journal
I'd start with a diagram and trace wires to the different circuits. Then you would be able to repair/replace anything that needs it and know how...
[ATTACH] [ATTACH] Nice project!
These seem to match up...? https://www.summitracing.com/parts/hly-108-100
Hoses plumbed correctly?
:eek:
May be it's not the "best", but I used this on my heap and it's still on there. Old Ford Blue[ATTACH]o_O
I'd probably blow some carb cleaner through, in an attempt to clean and dissolve any varnish built up inside.
I get 3-7/16" from the rear face of the housing, to the ring gear bulge on the cover...no gasket. I used a small square held flat against the...
Question. I inherited a Husqvarna Viking Designer 1. Briefly looking through the manual, I saw where it states it will sew leather, vinyl and...
Carter is my first choice for an electric fuel pump. Have used them for many years without an issue.
Stumbling under load can also be caused by low voltage in the ignition circuit. Connect a voltmeter to the ignition switch or coil, go for a...
Not long ago I worked on something similar. Pulling up the pedal fixed the brake drag. Found the cotter pin had been bent over the rod pivot and...
Word play. Hmm...should I go back to my first avatar? [ATTACH]
I'm baffled...
I had this problem and bought a cheap, polished shield for the starter. Doesn't look too weird. Their available for mini starters also...
Nice! So, the HH lifters are wrong. Weird they wouldn't pump solid on the bench. Wrong and defective...?
Might be a bad lifter. Those pushrods are known to bend/flex with high revs...one or more could be compromised. Check for a broken valve spring...
I did. I first used rubber based undercoating inside, then insulated the inner and outer sides of the doors with foil backed closed cell foam. I...
Gibb's oil is my go to for stuff like this.
Oh Boy! I'll be watching.
A flat tire should do it...
Umm, don't know. Last time I was at the local car gathering, I watched a a set of pipe tips get removed as one of the guys drug his way out of...
Hey Larry! Good to hear from you...been awhile. I've been thinking about you and that killer coupe lately. I've been looking at coups and you...
Might check out the Denny's Drive Shaft site. They had some decent info on them last time I was there. Good luck!
Plus, they'll keep the gremlins away... [ATTACH]:cool:
Sounds like there is air in the system. May need to pressure or vacuum bleed to get it out completely. The pushrod bolt should be done up in...
WHAT? 24 HOURS!! NOOooooo! :):cool:
Nice! Now that's thinkin outside the cabinet:cool:
Man, sad news. RIP BigO
Lifter should pump up hard on the bench. If it doesn't, something is causing it inside the lifter.
Separate names with a comma.