The Jalopy Journal
I have never done a brake line install. I am running a drum/drum system with the mc under the floor. Front brakes are from a 52 chevy and the rear...
Great responses, (Everyone) been working on the car for a while and " i am/get/was-am/get/was" you see the pattern just frustrated. I said i...
Working on a 41 Plymouth - The brake setup is not original. Got the power booster and master cylinder from Summit as a set.
I corrected the brake pedal travel, got the tool that holds the proportional valve in its center position. I see the spool moving when the pedal...
Ok, working on the brake system, 4 way disk brakes, right stuff proportional valve, Cardone master cylinder and power booster.Made my own lines...
Here's my 65 Ford F100
Well its been just about another year but the 41 is coming along. I've been installing the wiring harness and and i should be ready to fire it up...
I am wiring my brake light system. I purchased a power booster from Summit it has this one wire terminal coming from it, not sure what it is. I...
First time I took the distributor cap off., thought i would see points in it but it looks like some kind of electronic type. Also it looks like...
Ok, bought the two sensors (oil pressure and coolant temperature) from Summit, makes sense they are for the gauges i purchased from them. Next,...
Summit LED Digital Water Temperature Gauge Oreilly's Murray Climate Control 2 Terminal Temperature Unit Part #37980
I am installing a 22 circuit wiring harness in the 41. The engine is a 318, I am using a two wire engine coolant temperature sensor. I have one...
41 Plymouth Coupe I did the Explorer axle swap, building new rear lower shock mounts. Question- how much do I collapse the shock for proper...
Been about a year but just steadily moving along. There are some things that didn't turn out as planned but happy so far.Don't know if I can pull...
Was inspecting the 41 front suspension and noticed the upper control arm pin shifted back and forth. I was looking at the Plymouth service manual...
Put the disc brakes on, got the rack mounted in, and the column to rack gearbox linkage hooked up. Looking at how I'm going to hookup the tie rod...
Pulled the engine out again and welded the motor mounts in place, seems to be in the correct place. Still need to weld the trans mount pieces...
The motor mounts came from Butch's Cool Stuff
Set the engine and tranny into today. The motor is off set to the passenger side 7/8" . This is what I get when I pull the motor forward and the...
Damn-that's bad
I have used masking or duct tape.
Went to u-pull it today. Got the rear sump oil pan off a 85 pickup. Worked on a 93 caviler to get the R&P. Got everything loose but could not...
Fellow members After much research on this site you have given me the information and confidence to build this car. This car was missing the...
Fellow H.A.M.B. Alliance Members My name is Ken and I recently bought a 41 Plymouth P11. I've mostly built 4 wheel drives but I always wanted a...
Separate names with a comma.