The Jalopy Journal
Can anyone tell me how the cloth convertible top attaches to the Header Board. Pictures of installed top at the Header Board will be very helpful....
Anybody have knowledge of converting convertible top to hydraulic on a 40Ford?
Thank You!
Looking for help finding hydraulic cylinders for my 40 Convertible. Every thing is missing from my car so I have no measurements. I can make the...
I need to replace the whole unit in a 40 Ford Convertible. I cant see how to get into the B Pillar. Do I have to cut a piece of the back of the...
Its a 40 Ford Deluxe
I installed electric wiper motor from Speedway and install new towers with new arms. No matter what I do I cannot get the whole mechanism to work...
Looking for convertible top woods for 40 Ford. Seems very expensive. Does anyone have patterns so I can cut my own? Kube?
How do you remove the driveshaft (torque tube) from a 40 Ford Deluxe?
Can anyone tell me how to start a new thread? I find nothing on it.
I dont know how to start a new thread so Ill start here. Im building a 40 ford convertible that amounts to a shell on a rolling chassis. Ive seen...
Can anyone answer this? Im going to see a rear end not opened. I was told that there is a stamp or casting no that can tell me the ratio.
Im going to see a rear end not opened. I was told that there is a stamp or casting no that can tell me the ratio.
How do I tell what size ratio I have are there numbers stamped on the rear?
Can anyone tell me what length axle to axle I need for a 40 ford? Also what gear ratio is all around best for a 350 engine with a 350 auto tranny?
Can anyone please tell me if a 37 and 40 chassis are the same?
Hey thanks for the info and pics. The reason I asked is because I see replacement firewalls for Chevy engine installations for 40 fords. Yes I...
Anyone have any experience putting a small block Chev in a 40 Ford? Do I have to change out the firewall? I want to install a 350 with 350 or...
I just found that Yearone talks about a sleeve that goes into the Z bar maybe it has ends that receive the ball studs. Could it be?
I also have a 55 chev clutch problem. I am building a 55 chevy. Installed a new 350. The z bar seems to be missing parts. Aren't there...
Separate names with a comma.