The Jalopy Journal
Thanks guys, I’ll run with it.
While disassembling my dual Stromberg 97s I noticed that one of the carburetors has some damage to one of the 'tubes' in the air horn section. As...
Thanks for the info guys.
I was trying to get to 7°. I can't raise the wish bones at the rear any higher to reduce the Caster. It drives pretty good so I think I'll just...
Thanks Happydaze the car is done, this measurement is at ride height completely loaded (engine etc...)
Trying to understand Caster a little better. I have split wishbones on a 30 Model A. My question: What is my Caster? If I measure 10° at the king...
Thanks for the info Chris and pprather, I'll call them this morning.
Thanks pprather, your picture didn't come through. I'll call Limeworks this morning and see if they will sell me just the wire and contact switch....
Thanks pprather, my setup is an F1 steering column with the ground wire coming up through the steering shaft to the horn button. I would...
Thanks Phil, that looks like it might work plus it has a base to support the wire as it exits the steering shaft. Kind of surprised that no one...
302 GMC thanks for the response the wire in my picture comes from the ground pin on the relay. The horn works fine it’s just the wiring at the...
Wonder where I can get just the contact wire. $50 is a little steep for a wire and a spring.
Thanks for the quick replies. Dak Rat are those horn 'cup's available anywhere? Olscrounger thanks for the info let me know if you find a source...
Hoping to find someone who has installed a Limeworks steering wheel and can tell me what I am doing wrong. This wheel is second hand with no...
Thanks for all the advice. I've managed to locate an original 32 pitman arm which should solve my problems. I'll let you know how it turns out.
Thanks for all the suggestions guys. I have to buy a new pitman arm anyway because my current one [ATTACH] looks like this. I had to heat and bend...
Thanks Mart, so I wouldn't have to taper the engine side of the arm and it would fit an F1 box?
Does anyone know of an early Ford Pitman Arm with a reverse taper? I would like to mount a pitman arm similar to the one shown in this pic: [IMG]...
24riverview I wired up as you described and bingo, everything worked as it should. For anyone encountering this problem with 2 brake switch wires...
Thanks guys, I'll wire it up this way and report back.
I found part of my problem. I had joined the brake switch wire from the TS to the "Brake Switch" wire from the wiring harness and connected them...
With the ignition on and the brake lights lit up I removed the flasher and the brake lights stayed on. With the ignition on if you use either turn...
Using the test light, the wire from the brake switch to the Signal Stat lights up with the ignition on. The wire yellow (load) from the flasher to...
52hardtop, if you mean “As per” the diagram, then I don’t know. The diagram at the beginning of this post is from the Signal Stat 900...
I checked both brake wires from the Signal Stat switch with a test light. With ignition toggle “OFF” both wires show no power. With toggle “ON”...
Separate names with a comma.