The Jalopy Journal
I was a subscriber for years and received the last issue. I don't have a clue when my subscription expires but would gladly renew if I knew I...
What happened above the rear header?
If you haven't poured your floor yet we had a metal trough built which we mounted in the floor that ran different places so our wiring and air is...
It's a skinny building that even a crosley won't fit in. You sure can stack a lot of parts against the wall but then you have to leave a path so...
There are two tdc in every cycle so make sure its the correct one. Watch the intake open as the piston is going down and then as the piston is...
They have charged my credit card in the past since I don't have paypal
We have them on two different trailers and love them.
We have three in our 10,000 shop and couldn't be happier with them.
1927 Ford Tudor sedan which I paid $250 lawn mowing money for and still own it. First on the road was a 1953 Chevy convert that I paid 300 for....
Seems like good prices and in stock stuff but has anyone dealt with them? Yes I used search and and no results found.
My touch system in the middle of the wheel doesn't work correctly. Any gurus out there?
I can see stretched modified Corvette design in almost every one of them.
agree
You cannot camp at the swap meet if you don't have a space. There are camp grounds around the area.
I would use a c clamp on both sides of the bolt and also get a lot longer bolt to take it apart and start assembling it back together. When you...
That was the air mail delivery vehicle.
I have the same wish for a 1953 Chevy convert like I drove through high school. When I went into the Air Force at 17 my dad sold the car. I have...
I just pulled a Lincoln out of 10 years of storage with a flathead in it. I went through fuel and distributor and the car idled beautifully....
I am going from Indy
Your e-mail address bounced back and I haven't heard from you in ages
I just posted on the Lincoln Zephyr forum because I went through the exact thing. I only had second and third and I could not get my shifter to...
Bean Blossom is reopened in Indiana also 1/8th mile
Mine was 50 inches when I just measured it center of screw hole to center of screw hole.
If you are reaming the axle ends you have problems. The spindles are where the bushings are.
How did you find it? Lets hear the whole story.
My 56 Nomad I paid $585 and have had for 41 years and drive it a ton. My 27 Tudor sedan I have had since 1972. Engine is being built in Ohio as...
yup
I hope the winning 32.00 bid was yours.
With that big of stash you local boys had to know of this. Lots of neat stuff.
Slightly bent wheels will give you a wallowing feeling
Separate names with a comma.
The Jalopy Journal
