The Jalopy Journal
Welcome to the HAMB from Illinois. @Weedburner 40 might have some suggestions.
Or a speedo/tach combo gauge? Or a rebuilt, original Rambler gauge cluster?
What is the diameter of the gauge hole?
https://content.speedwaymotors.com/DigitalAssets/assets/testing/91049801_INS_2021_1.pdf?_gl=1*fey64s*_ga*MTExOTAxNDQxNC4xNzA1MzczMTMy*_ga_9NTXM7BJK...
Firewall and firewall seal discussion on page 6, during build, then continues on page 14, with final assembly:...
Mercury tailgate:...
I'd try to message the left front wheel opening slightly. Turn the steering wheel. Roll a piece of pipe or tubing between tire and wheel opening...
Route 66 in Arizona is very fun. I'm not sure Tod's '62 Corvette is a Lemon? Have fun, as always.
Here is info on triangulated four bar installation: https://www.heidts.com/inst/in-119.pdf
Welcome to the HAMB from Illinois.
You didn't indicate what rear suspension you are using; buggy spring or coil over shocks. Mine has buggy spring and the P&J triangulated ladder...
Welcome to the HAMB from Illinois. Please note that the forum rules don't allow discussion or photos of RR or frame swaps.. Enjoy the forum.
I've been using Castrol GTX Classic in my flat tappet engine....
https://www.jalopyjournal.com/forum/threads/32-3-window-build.1191581/
Just an fyi. Are passenger and pickup the same? https://www.jalopyjournal.com/forum/threads/33-4-walker-radiator.1310595/
My sister in law uses a grab handle on the inside A pillar to get up into their tall truck.
I say the bully step would be an easier instaĺl.
These radiators are expensive, but they are the best quality: https://johnsonsradiatorworks.com/
Some pickup fender info here: https://www.jalopyjournal.com/forum/threads/1934-ford-fenders.1004438/
I think the typical build sequence for a Deuce is mount the radiatorto the crossmember, mount the firewall to chassis, then determine firewall...
A lot of hardware, here: https://cwmoss.com/collections/screw-hardware-kits
On my Model A the wiper motor hole was in the header, above the windshield frame. Note, that was a slant window Victoria, which was designed...
Are you asking about using Google Lens to find photos on yhe internet that are similar to one you have on your computer?
That wiper motor looks like it would work. Put a nut and washer on thread. Stick thread through hole. Put washer and nut on outside of thread....
I think Lokar has e-brake cables that you cut to desired length. https://www.lokar.com/assets/instructions/INS0009-UniversalE-Brakes.pdf
Welcome to the HAMB from Illinois. You may get more response if you post your question over here:...
Back to the alternator bracket. When you add AC you will want the compressor and hoses on the right side running to the under dash unit. Modify...
Will this ride be ready for the HR100? I'm looking forward to seeing it sometime, down the road.
Nice steady progress!
Some ideas here: https://www.jalopyjournal.com/forum/threads/dimpling-valve-covers-how.706631/
Separate names with a comma.