The Jalopy Journal
Welcome back to the HAMB.
I have painted them using Dupli-Color caliper paint kit with very good results. ps, it was the brush on kit, not the spray cans.
Photos taken a couple of years ago, currently redoing the steering, wiring, fuel system & drivetrain. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]...
I had all the glass replaced by Robert Valentine @ Dirty Leg Inc. He cuts his own glass, you can look him up on Facebook.
That's good to know!!, It says to install the largest unit possible, but at 20.5" long the compact evaporator would have been mighty tight. So I...
Hotrodprimer, Did you go with the mini unit or the compac ? I'm working on cleaning up my firewall before attempting to install the Gen II mini,...
With!!!
[ATTACH]
About 20 years ago, I installed an Edelbrock cat back exhaust on a OT Chevy truck & was really pleased with it! IIRC
I have the same issue, sometimes I run with caps & rings and sometimes I take off or switch caps. It depends on what look I prefer on any given...
That looks like a really nice car show!! I would like to see better pictures of the red 1937 Chevrolet coupe in the 3rd photo.
You could fasten it on the opposite side of the firewall & it would be hidden and not seen in the engine bay.
I received the new plate last week and it looks way better than the old one! I never liked the old horseless carriage image in the middle of the...
The ballast resistor must be used to reduce the voltage, if not you will fry the electronic eye unit. It happened to me on my drag car many years...
I went to the nearest Tax Office last Thursday to re-register. I payed & was given a temporary paper plate & a 3/23 sticker. I have to wait for...
We evacuated to Bastrop, TX. We survived with no flooding, but were prepared none the less!!
Merry Christmas & Happy New Year!!
I enjoyed the meet very much, it was worth the 90+ mile drive just to meet some fellow HAMBers. BTW, the Strokers CC are the friendliest bunch I...
Sounds like a good call, see yall there on the 10th.
I plan on making it also. You never know, being a shift worker!!
I won't make it tomorrow. I installed a new alternator & had to rearrange some of the wiring under the hood. The ignition wire connector to the...
I agree that the Mustang II front does work fine. My '38 coupe has the Chassis Engineering MII front end and I have driven it many enjoyable miles...
I'll be there also!! I had a good time last year, lots of cars to see.
Making progress is what it's all about. Looking good too!!
I am in the process of converting from a LWP to the SWP on my small block Chevy. I went with Alan Grove Components #228L alternator setup &...
Sounds Great!!! I plan to be there, I'm having to redesign my cooling system for stop/go traffic situations & couldn't make this one.
Dead On Driveways Garages & Expressways
TTT
GOOD CHOICE!!!!!!!!
Separate names with a comma.